wtSeriPortState – Com-Server-Intern-MIB

Object

column mandatory Enumeration

This value specifies the the connection state of the serial port.
0=Server mode, no connection
1=Server mode, active connection
2=Special mode, attempting to establish a connection
3=Special mode, active connection or special mode configured (e.g. SLIP router)
4=Special mode, no connection
The values wtSeriRemotePort and wtSeriRemoteIP includes the belonging connection parameters

Context

MIB: Com-Server-Intern-MIB
OID: .1.3.6.1.4.1.5040.1.1.1.3.4.1.4
Type: column
Access: readonly
Status: mandatory
Parent: wtSeriPortEntry
Table: wtSeriPortTable
Siblings: 8

Syntax

Enumeration

Values & Constraints

Enumerated Values

`0`	wtSeriPortFree
`1`	wtSeriPortInUse
`2`	wtSeriPortLockScanning
`3`	wtSeriPortLockConnected
`4`	wtSeriPortLockUnconnected

Related Objects

Sibling Objects

Object	Type	Syntax	OID
wtSeriLocalPort mandatory Local TCP/UDP port number of the Com-Server port on which the Com-Server accepts a TCP connection or which it used in TCP client mode or UDP mode as a local port.	column	Integer32	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.1`
wtSeriNetPckDelay mandatory This value indicates the minimum wait time in 10ms ticks of the Com-Server after the arrival of serial data. After this time has expired, it packs the data into a network packet…	column	Integer32	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.10`
wtSeriFlushBuf mandatory If this switch is active (2), the serial buffer is flushed each time a new connection is opened; any residual data which could not be sent (e.g., handshake stop of the serial te…	column	Enumeration	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.11`
wtSeriTelnetEcho mandatory When opening a Telnet connection, there is negotiation on the network side to determine who generates the echo of the characters sent by the client. Either the client application …	column	Enumeration	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.12`
wtSeriPortMode mandatory This parameter specifies the mode of the Com-Server port. Depending on which mode is set, the corresponding list of the relevant parameters is available. If for example Upd mode …	column	Enumeration	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.2`
wtSeriControlPort mandatory TCP port number of the Com-Server's control port. In TCP client or TCP server mode this port allows to change settings like baud rate, parity etc. of the serial interface. The c…	column	Integer32	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.3`
wtSeriRemotePort mandatory If the serial port has an active TCP or UDP connection, this value shows the port number of the remote host.	column	Integer32	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.5`
wtSeriRemoteIP mandatory If the serial port has an active TCP or UDP connection, this value shows the IP address of the remote host.	column	RFC1155-SMIIpAddress	`.1.3.6.1.4.1.5040.1.1.1.3.4.1.6`