frxLoopLoc
Cisco90Series-MIB ·
.1.3.6.1.4.1.1570.1.6.3.1.3
Object
column
mandatory
r/w
Enumeration
This parameter indicates the location of the loopback or the card that will send corrupt CRC. It has no effect until frxStartTest is set to start the test. It has no effect for a BertOnly test. 7=Local Cisco 90 Series card 8=NT1 at customer premise 1 to 6 is used to address intervening BRITE cards.
Context
- MIB
- Cisco90Series-MIB
- OID
.1.3.6.1.4.1.1570.1.6.3.1.3- Type
- column
- Access
- readwrite
- Status
- mandatory
- Parent
- frxUEocEntry
- Table
- frxUEocTable
- Siblings
- 8
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | briteCard1 |
2 | briteCard2 |
3 | briteCard3 |
4 | briteCard4 |
5 | briteCard5 |
6 | briteCard6 |
7 | localFrx |
8 | nt1 |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| frxTestPort mandatory This parameter indicates which subscriber port on the
channel unit to test. It has no effect until frxStartTest
is set to start the test. Only one port on a given channel
unit may… | column | Integer32 | .1.3.6.1.4.1.1570.1.6.3.1.1 |
| frxTestType mandatory This parameter indicates the type of test to perform. It
has no effect until frxStartTest is set to start the test.
1=Set up a loopback and run a PN-2047 Bit Error Rate Test.
2=Ru… | column | Enumeration | .1.3.6.1.4.1.1570.1.6.3.1.2 |
| frxLoopCh mandatory This parameter indicates which channels to use for the
loopbackOnly and localLoopAllPorts test. It has no effect
until frxStartTest is set to start the test. Note that the
loopbac… | column | Enumeration | .1.3.6.1.4.1.1570.1.6.3.1.4 |
| frxStartTest mandatory This parameter is used to start and stop the test.
frxTestPort, frxTestType, frxLoopLoc, and frxLoopCh should
be set up prior to starting the test.
1=stop test. 2=start test. | column | Enumeration | .1.3.6.1.4.1.1570.1.6.3.1.5 |
| frxBertRst mandatory This parameter may be used during a LoopbackAndBert test
or a BertOnly test to reset the frxBertBE counter. It
must be returned to the normal posiion to allow errors to
be counted… | column | Enumeration | .1.3.6.1.4.1.1570.1.6.3.1.6 |
| frxBertBE mandatory BERT test block errors | column | RFC1155-SMICounter | .1.3.6.1.4.1.1570.1.6.3.1.7 |
| frxBertTestTime mandatory BERT test time in 0.01 second increments | column | RFC1155-SMITimeTicks | .1.3.6.1.4.1.1570.1.6.3.1.8 |
| frxTestInProg mandatory Test in progress (1); Normal operation (2) | column | Enumeration | .1.3.6.1.4.1.1570.1.6.3.1.9 |