rFUStatusTrap

CAMBIUM-PTP800-MIB · .1.3.6.1.4.1.17713.8.99.0.27

Object

notification

Current status of the RFU. A state of 'ok' indicates 
that the RFU is fully operational, although may not be 
transmitting.

Context

MIB: CAMBIUM-PTP800-MIB
OID: .1.3.6.1.4.1.17713.8.99.0.27
Type: notification
Status: current
Parent: ptpTrapPrefix
Siblings: 32

Syntax

No syntax metadata recorded.

Values & Constraints

No enumerated values or constraints recorded.

Related Objects

Sibling Objects

Object	Type	Syntax	OID
alignmentModeTrap Indicates if the unit is undergoing alignment. NB: a change of state during operation may generate an SNMP trap and/or SMTP email alert	notification	-	`.1.3.6.1.4.1.17713.8.99.0.10`
unitOutOfCalibrationTrap The unit is out of calibration	notification	-	`.1.3.6.1.4.1.17713.8.99.0.11`
encryptionEnabledMismatchTrap Encryption has been enabled on one end of the wireless link but not the other	notification	-	`.1.3.6.1.4.1.17713.8.99.0.13`
dataPortDisabledWarningTrap The SNMP ifAdminStatus of the data Ethernet interface has disabled Ethernet traffic	notification	-	`.1.3.6.1.4.1.17713.8.99.0.17`
dataPortFiberStatusTrap If the fiber interface on the data Ethernet port is not OK, there are three possible causes: 1) the fiber interface has been installed but disabled, 2) the interface could not …	notification	-	`.1.3.6.1.4.1.17713.8.99.0.18`
dataPortConfigurationMismatchTrap The detection of Ethernet fragments (runt packets) on the data Ethernet port when the link is in full duplex is an indication of an auto-negotiation or forced configuration mis…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.19`
softwareVersionRemoteCompatibilityTrap Indicates a mismatch of software versions at the two ends of the wireless link	notification	-	`.1.3.6.1.4.1.17713.8.99.0.20`
sNTPSyncTrap If SNTP Sync fails then check the server settings in the Remote Management page, or disable SNTP. NB: a change of state may generate an SNMP trap and/or SMTP email alert	notification	-	`.1.3.6.1.4.1.17713.8.99.0.21`
managementPortStatusTrap Current status of the out-of-band management Ethernet link	notification	-	`.1.3.6.1.4.1.17713.8.99.0.23`
managementPortDisabledWarningTrap The SNMP ifAdminStatus of the out-of-band management Ethernet interface has disabled Ethernet traffic	notification	-	`.1.3.6.1.4.1.17713.8.99.0.24`
managementPortConfigurationMismatchTrap The detection of Ethernet fragments (runt packets) on the out-of-band management Ethernet port when the link is in full duplex is an indication of an auto-negotiation or forced…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.28`
wirelessLinkStatusTrap Current status of the wireless link	notification	-	`.1.3.6.1.4.1.17713.8.99.0.29`
dataPortStatusTrap Current status of the data Ethernet link. NB: a change of state may generate an SNMP trap and/or SMTP email alert	notification	-	`.1.3.6.1.4.1.17713.8.99.0.3`
protectionAvailabilityStatusTrap In a 1+1 Hot Standby configuration, the Protection Availability Status attribute indicates whether the Active unit is currently being protected by the Inactive unit. If it isn'…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.31`
protectionConfigurationStatusTrap In a 1+1 Hot Standby configuration, this attribute will indicate whether the configuration will support protection.	notification	-	`.1.3.6.1.4.1.17713.8.99.0.32`
protectionStateTrap In a 1+1 Hot Standby configuration, only one CMU / RFU at a given end of the link is Active at any one time, the neighbor CMU / RFU being Inactive. The Protection State attribu…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.33`
wirelessReceiveSignalStatusTrap The Wireless Receive Signal Status indicates if the receiver is able to demodulate the transmit signal from the remote end of the link. If it cannot demodulate the signal, a pr…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.34`
licensedTransmitCapacityStatusTrap In a 1+1 Hot Standby configuration, the Licensed Transmit Capacity Status attribute indicates when the Licensed Transmit Capacity is below that of its neighbor.	notification	-	`.1.3.6.1.4.1.17713.8.99.0.36`
dataPortEthernetSpeedStatusTrap In a 1+1 Hot Standby configuration, the Data Port Ethernet Speed Status attribute indicates if the Ethernet Speed of the Data Port is below that of its neighbor.	notification	-	`.1.3.6.1.4.1.17713.8.99.0.37`
managementPortEthernetSpeedStatusTrap In a 1+1 Hot Standby configuration, the Management Port Ethernet Speed Status attribute indicates if the Ethernet Speed of the Management Port is below that of its neighbor.	notification	-	`.1.3.6.1.4.1.17713.8.99.0.38`
protectionInterfaceStatusTrap In a 1+1 Hot Standby configuration, information is shared between neighbor CMUs over the Protection Interface. The Protection Interface Status attribute reports whether the nei…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.39`
syslogStateTrap The syslog service has been enabled or disabled	notification	-	`.1.3.6.1.4.1.17713.8.99.0.40`
syslogLocalNearlyFullTrap The syslog local log is nearly full (90%)	notification	-	`.1.3.6.1.4.1.17713.8.99.0.41`
syslogLocalWrappedTrap The syslog local log has wrapped	notification	-	`.1.3.6.1.4.1.17713.8.99.0.42`
secureModeAlarmTrap The secure mode (e.g. FIPS, UC-APL) state of the unit. The secure mode is not configured(1) state indicates that the unit is capable of secure mode operation, and one or more o…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.43`
endWirelessReceiveSignalStatusTrap The End Wireless Receive Signal Status indicates if the end of a link is unable to demodulate the signal transmitted from the remote end of the link. When Protection is set to …	notification	-	`.1.3.6.1.4.1.17713.8.99.0.44`
rxDiversityDataPortStatusTrap When Receive Diversity is enabled, the Inactive CMU sends Rx Diversity Ethernet Frames to the Active CMU. Before sending these frames, the Data Port MUST be negotiated at 1000 …	notification	-	`.1.3.6.1.4.1.17713.8.99.0.45`
rxDiversityAvailabilityStatusTrap The Rx Diversity Availability Status attribute will indicate when Receive Diversity is not operating correctly, either due to a fault or due to an incorrect configuration	notification	-	`.1.3.6.1.4.1.17713.8.99.0.46`
rxDiversityConfigurationStatusTrap For Receive Diversity to operate correctly, certain attributes must be configured correctly on both neighbor CMUs. The Rx Diversity Configuration Status attribute will indicate…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.47`
rFUPowerButtonPressedTrap IRFU power button have been pressed, IFRU has powered down unexpectedly	notification	-	`.1.3.6.1.4.1.17713.8.99.0.48`
syslogClientTrap Enable or disable the syslog client	notification	-	`.1.3.6.1.4.1.17713.8.99.0.49`
linkNameMismatchTrap Signaling was received with the wrong Link Name. Either the Link Name is configured differently at each end of the wireless link, or this unit is aligned to the wrong link part…	notification	-	`.1.3.6.1.4.1.17713.8.99.0.9`

Notification Objects