dataPortFiberStatusTrap
CAMBIUM-PTP600-MIB ·
.1.3.6.1.4.1.17713.6.99.0.18
Object
notification
If the fiber link is not OK, there are three possible causes: Either the fiber link has been installed but disabled (because the license key does not include fiber support), the link could not be established even though no LOS was detected (i.e. an optical carrier was detected, which could be due to a broken TX fiber, or because the link is disabled at the fiber link partner), or the link could not be established and LOS is detected (i.e. no optical carrier is detected). NB: a change of status may generate an SNMP trap and/or SMTP email alert
Context
- MIB
- CAMBIUM-PTP600-MIB
- OID
.1.3.6.1.4.1.17713.6.99.0.18- Type
- notification
- Status
- current
- Parent
- ptpTrapPrefix
- Siblings
- 29
Syntax
No syntax metadata recorded.
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| channelChangeTrap The PTP radio has changed wireless channel.
This has been caused by either
i) mandatory radar avoidance,
a DFS impulsive interference event will also be
detected,
or
ii) Dyn… | notification | - | .1.3.6.1.4.1.17713.6.99.0.1 |
| installArmStateTrap Indicates if the unit is being installed. NB: a change
of state may generate an SNMP trap and/or SMTP email
alert | notification | - | .1.3.6.1.4.1.17713.6.99.0.10 |
| unitOutOfCalibrationTrap The unit is out of calibration | notification | - | .1.3.6.1.4.1.17713.6.99.0.11 |
| incompatibleRegionCodesTrap The master and slave units have incompatible region
codes. NB: Both units must have compatible license keys | notification | - | .1.3.6.1.4.1.17713.6.99.0.14 |
| noWirelessChannelAvailableTrap Spectrum Management was unable to locate a suitable
wireless channel to operate on | notification | - | .1.3.6.1.4.1.17713.6.99.0.15 |
| wirelessLinkDisabledWarningTrap The SNMP ifAdminStatus of the wireless interface has
disabled wireless traffic | notification | - | .1.3.6.1.4.1.17713.6.99.0.16 |
| dataPortDisabledWarningTrap The SNMP ifAdminStatus of the Ethernet interface has
disabled Ethernet traffic | notification | - | .1.3.6.1.4.1.17713.6.99.0.17 |
| dataPortConfigurationMismatchTrap The detection of Ethernet fragments (runt packets) when
the link is in full duplex is an indication of an
auto-negotiation or forced configuration mismatch | notification | - | .1.3.6.1.4.1.17713.6.99.0.19 |
| dfsImpulsiveInterferenceTrap DFS impulsive interference detected event | notification | - | .1.3.6.1.4.1.17713.6.99.0.2 |
| incompatibleMasterAndSlaveTrap A non-zero value indicates that the master and slave
ends of a link are different hardware products, or have
different software versions. NB: It is very unusual to
detect this,… | notification | - | .1.3.6.1.4.1.17713.6.99.0.20 |
| sNTPSyncTrap If SNTP Sync fails then check the server settings in the
Remote Management page, or disable SNTP | notification | - | .1.3.6.1.4.1.17713.6.99.0.21 |
| tDDSynchronizationAlarmTrap Not Synchronized indicates failure of the external
timing system for a period greater than the holdover
timer. TDD frame timing will have drifted, and this link
may cause inter… | notification | - | .1.3.6.1.4.1.17713.6.99.0.22 |
| managementPortStatusTrap Current status of the out-of-band management link. NB: a
change of state may generate an SNMP trap and/or SMTP
email alert | notification | - | .1.3.6.1.4.1.17713.6.99.0.23 |
| managementPortDisabledWarningTrap The SNMP ifAdminStatus of the out-of-band management
interface has disabled Ethernet traffic | notification | - | .1.3.6.1.4.1.17713.6.99.0.24 |
| linkModeOptimizationMismatchTrap The remote node of this link has been configured with a
different link mode optimization | notification | - | .1.3.6.1.4.1.17713.6.99.0.25 |
| managementPortConfigurationMismatchTrap The detection of Ethernet fragments (runt packets) when
the link is in full duplex is an indication of an
auto-negotiation or forced configuration mismatch. This
alarm is only … | notification | - | .1.3.6.1.4.1.17713.6.99.0.28 |
| dataPortStatusTrap Current status of the Ethernet link. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.6.99.0.3 |
| syslogStateTrap The syslog service has been enabled or disabled | notification | - | .1.3.6.1.4.1.17713.6.99.0.30 |
| syslogLocalNearlyFullTrap The syslog local log is nearly full (90%) | notification | - | .1.3.6.1.4.1.17713.6.99.0.31 |
| syslogLocalWrappedTrap The syslog local log has wrapped | notification | - | .1.3.6.1.4.1.17713.6.99.0.32 |
| syslogClientTrap Enable or disable the syslog client | notification | - | .1.3.6.1.4.1.17713.6.99.0.33 |
| secureModeAlarmTrap The secure mode (e.g. FIPS, UC-APL) state of the unit.
The secure mode is not configured(1) state indicates that
the unit is capable of secure mode operation, and one or
more o… | notification | - | .1.3.6.1.4.1.17713.6.99.0.34 |
| ethernetBridgingStatusAlarmTrap Ethernet traffic bridging is disabled because the
wireless link is not operating at the configured Lowest
Ethernet Modulation Mode | notification | - | .1.3.6.1.4.1.17713.6.99.0.35 |
| telecomsChannelAStatusTrap Current status of telecoms channel A. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.6.99.0.4 |
| telecomsChannelBStatusTrap Current status of telecoms channel B. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.6.99.0.5 |
| channelALoopbackTrap The loopback status of telecoms channel A. This is
intended for installation testing and should be set to
'None' for normal operation. The wire connections to a
unit can be tes… | notification | - | .1.3.6.1.4.1.17713.6.99.0.6 |
| channelBLoopbackTrap The loopback status of telecoms channel B. This is
intended for installation testing and should be set to
'None' for normal operation. The wire connections to a
unit can be tes… | notification | - | .1.3.6.1.4.1.17713.6.99.0.7 |
| regionCodeTrap The region code prohibits the wireless unit from
operating outside the regulated limits. An invalid region
code indicates a corrupted license key. NB: a change of
state may gen… | notification | - | .1.3.6.1.4.1.17713.6.99.0.8 |
| installStatusTrap A non-zero value indicates that signalling was received
with the wrong MAC address or a mismatched link name. NB:
It is very unusual to detect this, because units with
mis-conf… | notification | - | .1.3.6.1.4.1.17713.6.99.0.9 |
Notification Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| dataPortFiberStatus If the fiber link is not OK, there are three possible
causes: Either the fiber link has been installed but
disabled (because the license key does not include fiber
support), th… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.8 |