cadDownChannelMinFrequency

CADANT-CMTS-DOWNCHANNEL-MIB · .1.3.6.1.4.1.4998.1.1.15.2.2.2
MIB view Table view

Object

scalar r/w hertz Integer32 
This object is used to configure the C4 CMTS to accept minimum downstream
frequency limit that conform with the EuroDOCSIS specifications
(starndard range 112 MHz to 858 MHz), (extended 85 MHz to 999MHz)
or to the DOCSIS specifications (standard 91 to 867 MHz), (extended range 57 MHz to 999 MHz).
Changes to downstream frequency and width are verified against this
object to ensure the C4 CMTS does not exceed the downstream spectrum
limits imposed by this object. Attempting to increase the minimum downstream
frequency limit implied by this object will fail if at least
a single downstream is configured outside of the range for the new
value. It is recommended this object be set during initial system
setup.

Context

MIB
CADANT-CMTS-DOWNCHANNEL-MIB
OID
.1.3.6.1.4.1.4998.1.1.15.2.2.2
Type
scalar
Access
readwrite
Status
current
Units
hertz
Parent
cadDownChannelParams
Siblings
9

Syntax

hertz Integer32

Values & Constraints

Object Constraints
range: 57000000-57000000 range: 85000000-85000000 range: 91000000-91000000 range: 112000000-112000000

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
cadDownChannelMaxFrequency
This object is used to configure the C4 CMTS to accept maximum downstream frequency limit that conform with the EuroDOCSIS specifications (starndard range 112 MHz to 858 MHz), (ex…
scalarhertz Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.1
cadDownChannelVoiceShaping
This parameter defines whether downstream voice packets should be shaped or not. When this this parameter is set to false, voice packets that do not conform to the policing param…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.4998.1.1.15.2.2.10
cadDownChannelAgcEnable
Enable Automatic Gain Control on DCAMs.
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.4998.1.1.15.2.2.3
cadDownChannelOorRecoveryEnable
True to enable toggling the Sequence Change Count for a DSID in response to a CM-STATUS sequence number Out-Of-Range message.
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.4998.1.1.15.2.2.4
cadDsOfdmOcdDpdPlcInterval
How often to send the OCD and DPD messages on a channel over the PLC.
scalarmilliseconds Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.5
cadDsOfdmDpdProfAInterval
How often to send the DPD messages on a channel using profile A.
scalarmilliseconds Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.6
cadDownChannelLsredMinThresh
This parameter defines the start of the downstream latency region where packets are randomly dropped. This value must be less than or equal to cadDownChannelLsredMaxThresh.
scalarmilliseconds Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.7
cadDownChannelLsredMaxThresh
This parameter defines the end of the downstream latency region where packets are randomly dropped. This value must be greater than or equal to cadDownChannelLsredMinThresh.
scalarmilliseconds Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.8
cadDownChannelLsredMaxProb
This parameter defines the drop probability of a packet when its downstream latency is equal to cadDownChannelLsredMaxThresh. The probability of dropping a packet varies linearly …
scalar0.01% Integer32.1.3.6.1.4.1.4998.1.1.15.2.2.9