atmfM4VcTestType
ATM-FORUM-SNMP-M4-MIB ·
.1.3.6.1.4.1.353.5.1.3.1.1.26.1.4
Object
A control variable used to start and stop operator-
initiated interface tests. Most OBJECT IDENTIFIER
values assigned to tests are defined elsewhere, in
association with specific types of interface.
However, this document assigns a value for a full-
duplex loopback test, and defines the special meanings
of the subject identifier:
noTest OBJECT IDENTIFIER ::= { 0 0 }
When the value noTest is written to this object, no
action is taken unless a test is in progress, in which
case the test is aborted. Writing any other value to
this object is only valid when no test is currently in
progress, in which case the indicated test is
initiated.
When read, this object always returns the most recent
value that atmfM4VcTestType was set to. If it has not been
set since the last initialization of the network
management subsystem on the agent, a value of noTest
is returned.
Context
- MIB
- ATM-FORUM-SNMP-M4-MIB
- OID
.1.3.6.1.4.1.353.5.1.3.1.1.26.1.4- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- atmfM4VcTestEntry
- Table
- atmfM4VcTestTable
- Siblings
- 6
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| atmfM4VcTestObject Specifies whether the test applies to the VCL termination
point with the specified VPI and VCI values, or to the VCC
termination point. | column | Enumeration | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.1 |
| atmfM4VcTestId This object identifies the current invocation of the
interface's test. | column | SNMPv2-TCTestAndIncr | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.2 |
| atmfM4VcTestStatus This object indicates whether or not some manager
currently has the necessary 'ownership' required to
invoke a test on this interface. A write to this
object is only successful w… | column | Enumeration | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.3 |
| atmfM4VcTestResult This object contains the result of the most recently
requested test, or the value none(1) if no tests have
been requested since the last reset. Note that this
facility provides n… | column | Enumeration | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.5 |
| atmfM4VcTestCode This object contains a code which contains more
specific information on the test result, for example
an error-code after a failed test. Error codes and
other values this object m… | column | ObjectIdentifier | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.6 |
| atmfM4VcTestOwner The entity which currently has the 'ownership'
required to invoke a test on this termination point. | column | IF-MIBOwnerString | .1.3.6.1.4.1.353.5.1.3.1.1.26.1.7 |