aluExtPortEtherLoopback
ALU-PORT-MIB ·
.1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.2
Object
column
r/w
Enumeration
aluExtPortEtherLoopback is used to put an ethernet port into a loopback mode.
Setting aluExtPortEtherLoopback must be accompanied by setting aluExtPortEtherLoopbackTimer
for the same port.
A 'line' loopback loops frames received on this port back to the remote system.
An 'internal' loopback loops frames from the local system back at the framer.
Use 'none' to turn off either one of the above loopback mode.
The Nokia 7705 SAR devices restrict the following interactions:
- A 'line' loopback is only allowed on ports with aluExtPortEtherLoopbackCfmLbMode set to 'disabled'.
- An 'internal' loopback is only allowed on ports with tmnxPortMode set to 'access (1)'.
- aluExtPortEtherLoopback can only be 'none' if dot3OamAdminState of the port is 'enable (2)'.
- aluExtPortEtherLoopback can only be 'none' if aluExtPortEtherLoopbackCfmLbMode of the port is not 'disabled (0)'.
Context
- MIB
- ALU-PORT-MIB
- OID
.1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- aluExtTmnxPortEtherEntry
- Table
- aluExtTmnxPortEtherTable
- Siblings
- 28
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | none |
1 | line |
2 | internal |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| aluExtPortEtherSfpSyncEStatus The value of aluExtPortEtherSfpSyncEStatus indicates whether or not
the SFP installed in the port is capabable of supporting synchronous
Ethernet (syncE) communications.
… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.1 |
| aluExtPortEtherLoopbackSwapMacAddr This variable indicates if Source and Destination MAC addresses in the packets are to be
interchanged before being loopbacked to the sender. Setting aluExtPortEtherLoopbackSwapMa… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.10 |
| aluExtPortEtherAdminPhyTxClock The value of aluExtPortEtherAdminPhyTxClock indicates the mode
used to establish timing control of a 1000BASE-T port. The
aluExtPortEtherAdminPhyTxClock is used to control the se… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.11 |
| aluExtPortEtherOperPhyTxClock The value of aluExtPortEtherOperPhyTxClock indicates the operational
value of the MASTER-SLAVE Configuration Resolution bit of register 10
from Table 40-3 of IEEE 802.3-2008. When… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.12 |
| aluEthPtpTimestampCapable The aluEthPtpTimestampCapable indicates whether
the hardware is capable of supporting 1588 PTP time stamp
functions. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.13 |
| aluEthPtpTimestampEnable the aluEthPtpTimestampEnable attribute indicate whether
the port is enabled to support 1588 PTP edge time stamp
functions. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.14 |
| aluEthPtpAsymmetry obsolete aluEthPtpAsymmetry is a path asymmetry correction value
that is used to specify the difference in transmission time
between master-to-slave and slave-to-master. The value
can be … | column | nanoseconds Integer32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.15 |
| aluExtPortEtherLoopbackPersist Setting this variable to 'true' indicates the configuration of aluExtPortEtherLoopback,
aluExtPortEtherLoopbackPersist, aluExtPortEtherLoopbackSwapMacAddr can be saved
to persist… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.16 |
| aluPortEtherIngressRateCbs aluPortEtherIngressRateCbs specifies the committed burst size that hard policer can accept while complying
to the ingress rate tmnxPortEtherIngressRate of the port.
… | column | bytes Unsigned32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.17 |
| aluPortEtherIngressRateSrcPause aluPortEtherIngressRateSrcPause indicates whether to send a pause frame for every dropped packet
by the hard policer when tmnxPortEtherIngressRate is > 0.
aluPortE… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.18 |
| aluPortEtherXorMode The aluPortEtherXorMode variable specifies the type of physical connector
for MDA ports which support configurable connector type. aluPortEther
must be 'notApplicable' if the MDA … | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.19 |
| aluPortEtherEgrUnshapedSapCir The value of aluPortEtherEgrUnshapedSapCir specifies the egress CIR of all unshaped SAPs,
i.e. all SAPs using this port that have aluSapEgressSchedulerMode in 4-priority-mode. | column | kbps Integer32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.20 |
| aluExtPortEtherVlanFilter aluExtPortEtherVlanFilter specifies the VLAN filter provisioned for bridge ethernet
ports. The value -1 indicates that no VLAN filter is configured. | column | Integer32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.21 |
| aluExtPortEtherCfmLbVlanList The aluExtPortEtherCfmLbVlanList is an OCTET STRING in which a list of Vlan Ids to be enabled for cfm Loopback when
aluExtPortEtherLoopbackCfmLbMode is priority-dot1p.
… | column | OctetString | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.22 |
| aluExtPortEtherAccEgrShaper aluExtPortEtherNetEgrShaper contains the access egress shaper policy if the tmnxPortMode is hybrid.
Otherwise this object has no significance. | column | TIMETRA-TC-MIBTNamedItemOrEmpty | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.23 |
| aluExtPortEtherNetEgrShaper aluExtPortEtherNetEgrShaper contains the network egress shaper policy if the tmnxPortMode is hybrid.
Otherwise this object has no significance. | column | TIMETRA-TC-MIBTNamedItemOrEmpty | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.24 |
| aluPortEtherEgrUnshapedNwIfCir The value of aluPortEtherEgrUnshapedNwIfCir specifies the egress CIR of all unshaped network interfaces
on this port, i.e. those network interfaces on this port without a network… | column | kbps Integer32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.25 |
| aluExtPortEtherEgrRateIncludeFCS This variable indicates if the value of tmnxPortEtherEgressRate of the port includes 4 bytes
of ethernet frame check sequence (FCS). | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.26 |
| aluPortEtherOperXorMode The aluPortEtherOperXorMode specifies the type of physical connector used
when MDA ports are configured as auto xor mode. aluPortEtherOperXorMode
must be 'notApplicable' if the MD… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.27 |
| aluExtPortEtherBnAllowed The aluExtPortEtherBnAllowed allows the handling of the received ETH-BN to be processed,
and possibly to enforce the bandwidth indicated in the ETH-BN by changing the egress-rate
… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.28 |
| aluExtPortEtherBnHoldTime aluExtPortEtherBnHoldTime is the time interval to hold aluExtPortEtherBnEgressRateInUse
when changed. This guards against excessive rate changes.
aluExtPortEtherBn… | column | seconds Unsigned32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.29 |
| aluExtPortEtherLoopbackTimer aluExtPortEtherLoopbackTimer is used to specify the time duration, in seconds, to set the ethernet port
into a loopback mode. Setting aluExtPortEtherLoopbackTimer to a non-zero v… | column | Unsigned32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.3 |
| aluExtPortEtherLoopbackTimeLeft aluExtPortEtherLoopbackTimeLeft is used to specify the number of seconds left since the loopback has started.
0 if aluExtPortEtherLoopbackTimer was assigned 0, or when aluExtPortE… | column | Unsigned32 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.4 |
| aluExtPortEtherNwSchedulerMode The value of aluExtPortEtherNwSchedulerMode indicates the mode that the
egress scheduler is provisioned to operate in.
profile - Basic in/out scheduling
four… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.5 |
| aluExtPortEtherLoopbackCfmLbMode aluExtPortEtherLoopbackCfmLbMode is to enable/disable an ethernet port to reply to an ethernet CFM
Loopback Message (LBM) frame at the port level. If enabled then it indicates th… | column | Enumeration | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.6 |
| aluExtPortEtherCfmLbmRx aluExtPortEtherCfmLbmRx indicates the received number of Ethernet
CFM Loopback messages (ETH-LBM) with destination MAC address matches
tmnxPortMacAddress of this port, while aluE… | column | SNMPv2-SMICounter64 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.7 |
| aluExtPortEtherCfmLbmDropped aluExtPortEtherCfmLbmDropped indicates the number of received, but
discarded Ethernet CFM Loopback messages (ETH-LBM) at this port
while its aluExtPortEtherLoopbackCfmLbMode is en… | column | SNMPv2-SMICounter64 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.8 |
| aluExtPortEtherCfmLbrTx aluExtPortEtherCfmLbrTx indicates the number of Ethernet CFM
Loopback Replies (ETH-LBR) that were sent back to the sender, in reponding to the
received ETH-LBM at this port while … | column | SNMPv2-SMICounter64 | .1.3.6.1.4.1.6527.6.1.2.2.2.4.2.1.9 |