acsModemsTablePppAddressConfig

ACS8000-MIB · .1.3.6.1.4.1.10418.26.2.8.2.1.8
MIB view Table view

Object

column r/w Enumeration 
Supported only if acsModemsTableProfile is set to dial-out(2).
If none(1) or remote(3) is set, then the IP address fields will be cleared.
When at least one IP address is set, this value will be local(2).
If remote(3) is set, the remote peer should send both IP addresses (local
and remote) during negotiation.

Context

MIB
ACS8000-MIB
OID
.1.3.6.1.4.1.10418.26.2.8.2.1.8
Type
column
Access
readwrite
Status
current
Parent
acsModemsTableEntry
Table
acsModemsTable
Siblings
36

Syntax

Enumeration

Values & Constraints

Enumerated Values
0notApplicable
1none
2local
3remote

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
acsModemsTableNumber
A unique index representing an entry in this table.
columnInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.1
acsModemsTableRemoteIpv4Address
Configures the remote IPv4 address for the PPP connection.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.10
acsModemsTableLocalIPv6Address
Configures the local IPv6 address for the PPP connection.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.11
acsModemsTableRemoteIPv6Address
Configures the remote IPv6 address for the PPP connection.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.12
acsModemsTablePppAuthentication
Configure the PPP authentication protocol. If this is set to remoteChap(5) or remotePap(6), then you must also set acsModemsTablePppRemoteUsername and acsModemsTablePppRemotePass…
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.13
acsModemsTablePppRemoteUsername
Only used if acsModemsTablePppAuthentication is set to remoteChap(5) or remotePap(6).
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.14
acsModemsTablePppRemotePassphrase
Only used if acsModemsTablePppAuthentication is set to remoteChap(5) or remotePap(6).
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.15
acsModemsTableChapInterval
CHAP Interval in seconds. Default is 0. Not used for integrated cellular modem.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.16
acsModemsTableChapMaxChallenge
CHAP Max Challenge value in seconds. Default is 10 seconds. Not used for integrated cellular modem.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.17
acsModemsTableChapRestart
CHAP Restart value in seconds. Default is 3 seconds. Not used for integrated cellular modem.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.18
acsModemsTablePppIdleTimeout
PPP idle timeout value in seconds. Default is 0. Not used for integrated cellular modem.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.19
acsModemsTableDeviceName
The associated device name for the modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.2
acsModemsTableModel
Modem vendor model name. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.20
acsModemsTableCellProvider
Cellular modem service provider. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.21
acsModemsTableCellRegistration
Cellular modem network registration. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.22
acsModemsTableCCID
SIM integrated circuit card identifier. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.23
acsModemsTableIMSI
International mobile subscriber identity. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.24
acsModemsTableIMEI
International mobile equipment identity. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.25
acsModemsTableCellStatus
Shows the status of the cellular modem. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.26
acsModemsTableAPN
Access point name. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.27
acsModemsTableMtuSize
The maxiumum transmission unit size for use by the integrated cellular modem.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.10418.26.2.8.2.1.28
acsModemsTableReplaceDefaultRoute
If this is set to enabled(2), then the integrated cellular modem becomes the default gateway. Only used for integrated cellular modem.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.29
acsModemsTableStatus
Enables or disbles the modem.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.3
acsModemsTablePersistMode
If this is set to 'yes' then the integrated cellular modem connection persists. Only used for integrated cellular modem.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.30
acsModemsTableSignalQualityCheck
Check the signal quality of the integrated cellular modem. This turns on the modem transceiver to get the signal. The signal quality can be read in acsModemsTableSignalQualityDi…
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.31
acsModemsTableSignalQualityDisplay
Displays the last read signal quality of the integrated cellular modem. To refresh this value write signalCheck(2) to acsModemsTableSignalQualityCheck.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.32
acsModemsTableSIMStatus
Status of the modem SIM card. Only used for integrated cellular modem.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.33
acsModemsTableSIMPINEntry
Modem SIM card PIN/Password entry. Writable only if acsModemsTableSIMStatus returns waitingForPIN(2). Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.34
acsModemsTableSIMUnlockCodeEntry
Modem SIM card Unlock Code entry. Writable only if acsModemsTableSIMStatus returns waitingForUnlockCode(3). Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.35
acsModemsTableCellTestLastStarted
The timestamp of the last time the Cell Modem IP Test started running. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.36
acsModemsTableCellTestLastResult
The result of the last time the Cell Modem IP Test was run. Only used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.37
acsModemsTableProfile
The modem profile. For an integrated cell modem, only dial-out(3) is valid.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.4
acsModemsTablePhoneNumber
The dial-out phone number. Only supported if acsModemsTableProfile is set to dial-out(3). Not used for integrated cellular modem.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.5
acsModemsTableComSpeed
The modem speed. Speeds above 230400 not supported by serial port modems.
columnEnumeration.1.3.6.1.4.1.10418.26.2.8.2.1.6
acsModemsTableInitChat
Modem initialization string.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.7
acsModemsTableLocalIpv4Address
Configures the local IPv4 address for the PPP connection.
columnOctetString.1.3.6.1.4.1.10418.26.2.8.2.1.9