BIANCA-BRICK-X21-MIB Table View
Table-centric layout grouping table, row, and column objects.
Tables
1
Rows
1
Columns
22
.1.3.6.1.4.1.272.4.10.1
·
1 row entry
·
22 columns
The x21IfTable contains information relating to the
interfaces found on the system. Each entry corresponds to
a connected X21 interface. Entries can only be added or
deleted by the system.
Creating entries: Entries are created by the system
only when a new X21 module is installed.
Deleting entries: Entries are removed by the system
after the appropriate X21 module is removed.
Indexes
x21IfIndex
| Column | Syntax | OID | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
x21IfIndex
mandatory
Unique index of the X21 interface.
|
Integer32 Textual Convention: COPS-PR-SPPIInteger32 Integer32Type Constraints: range: -2147483648..2147483647 |
.1.3.6.1.4.1.272.4.10.1.1.1 |
||||||||||||||||||||||
|
x21IfL1State
mandatory
The X21 physical layer state
dn(1) physical layer is inactive; up(2) physical layer is active; |
Enumeration Enumerated Values:
|
.1.3.6.1.4.1.272.4.10.1.1.2 |
||||||||||||||||||||||
|
x21IfL1Mode
mandatory
The physical layer (layer 1) mode. When configured as
DCE(2) the X21 interface provides the clock. |
Enumerationr/w Enumerated Values:
|
.1.3.6.1.4.1.272.4.10.1.1.3 |
||||||||||||||||||||||
|
x21IfIfLeads
mandatory
The value of IfLeads has influence on the state of the
physical layer (L1State). When configured as IfLeads=enabled(1), the state of the physical layer depends on the signals of the X.21 interface pins `Indication' and … |
Enumerationr/w Enumerated Values:
|
.1.3.6.1.4.1.272.4.10.1.1.4 |
||||||||||||||||||||||
|
x21IfSpeed
mandatory
The X21 interface speed in bits per second. The range
can be configured between 2Mbits and 2400 Bits per second. |
Enumerationr/w Enumerated Values:
|
.1.3.6.1.4.1.272.4.10.1.1.5 |
||||||||||||||||||||||
|
x21IfL2Mode
mandatory
The layer 2 mode. This value has influence on the
HDLC address field (first byte of a HDCL frame). When configured as DTE(1) the address in a command frame is 0x01, when configured as DCE(2) it is 0x03. For response fra… |
Enumerationr/w Enumerated Values:
|
.1.3.6.1.4.1.272.4.10.1.1.6 |
||||||||||||||||||||||
|
x21IfSpeedReal
mandatory
The measured X21 interface speed in bits per second.
|
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.7 |
||||||||||||||||||||||
|
x21IfRxPackets
mandatory
Count of received valid Frames.
|
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.8 |
||||||||||||||||||||||
|
x21IfRxOctets
mandatory
Count of received bytes.
|
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.9 |
||||||||||||||||||||||
|
x21IfTxPackets
mandatory
Count of transmitted valid Frames.
|
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.10 |
||||||||||||||||||||||
|
x21IfTxOctets
mandatory
Count of transmitted bytes.
|
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.11 |
||||||||||||||||||||||
|
x21IfRxResets
mandatory
Count of receiver resets. Under rare circumstances it
might be necessary to reset the receiver to work properly. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.12 |
||||||||||||||||||||||
|
x21IfRxAborts
mandatory
Count of receiver aborts. The sender of a frame can
indicate a frame as aborted with a special Abort sequence. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.13 |
||||||||||||||||||||||
|
x21IfRxOverruns
mandatory
Count of receiver overruns. If the X21 card is unable
to grant sufficiently soon/often the bus, the 32-character RxFIFO may fill up. This leads to loss of data. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.14 |
||||||||||||||||||||||
|
x21IfRxCRCErrors
mandatory
Count of corrupted frames. Errors due to interference
on the X21 cable. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.15 |
||||||||||||||||||||||
|
x21IfRxGiantFrames
mandatory
Count of received frames with illegal framesize. This
can occur if a frame delimiter is destroyed. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.16 |
||||||||||||||||||||||
|
x21IfTxResets
mandatory
Count of transmitter resets. Under rare circumstances
it might be necessary to reset the transmitter to work properly. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.17 |
||||||||||||||||||||||
|
x21IfTxAborts
mandatory
Count of transmitter aborts. While sending a frame it
might be necessary to indicate this frame as aborted. In this case the receiver regards this frame as illegal. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.18 |
||||||||||||||||||||||
|
x21IfTxUnderruns
mandatory
Count of transmitter underruns. The serial data for the
X21 card is supplied too slowly. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.19 |
||||||||||||||||||||||
|
x21IfTxGiantFrames
mandatory
Count of transmitted frames with illegal
framesize. This can occur if an upper module creates packets with more than the maximum allowed packet size. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.20 |
||||||||||||||||||||||
|
x21IfIfReSyncs
mandatory
Count of interface resynchronization. Under rare
circumstances it might be necessary to resynchronize the physical interface to work properly. |
RFC1155-SMICounter Textual Convention: RFC1155-SMICounter Unsigned32Type Constraints: range: 0..4294967295 |
.1.3.6.1.4.1.272.4.10.1.1.21 |
||||||||||||||||||||||
|
x21IfBundle
mandatory
Index of the bundle to aggregate multiple Channels
to one interface. |
Integer32r/w Constraints: range: 0-255 |
.1.3.6.1.4.1.272.4.10.1.1.22 |