ADTRAN-GENMAX-ACCESSORY-MIB Table View

A unique value for each accessory.
This object is visible for all rows.

A unique value for each accessory module.
This object is visible for all rows.

The state of the card slot. Initially it is empty.
When a card is inserted, it becomes occupied, and the
Slot Type is determined by the card Product Code.
When a card is removed, it changes to virtual,
and retains the S…

The ADTRAN Product code. Agent will report
real product code when installed or pre-provisioned.
This object is visible for all rows. It is defined in the ADTRAN-TC.

Enables/Disables traps initiated from this slot. Note that
cards out of service will not generate traps.

A bit encoded string representing the alarm state of
the slot. The LSB should be 1 for No Alarm, else 0 and
the higher order bits will indicate which alarms are
present. The specific alarm conditions may be found in
mor…

A bit encoded string representing the status of faceplate
indicators, LEDs, buttons & switches for GUI visualization.
The first byte will be the number of LED/switches encoded.
The following bytes will contain 2 bit seq…

Module service state. Port service states are commanded via
ifAdminStatus and reported via ifOperStatus in the IF-MIB.
Those states of up, down, & testing correspond to the first
three states defined here for the card.

The number of physical ports (regardless of
their current state) present in this slot.

A counter starting at 0 which is incremented by the agent
after each provisioning change so that an EMS can detect that
a change has been made locally that needs further investigation
to achieve synchronization.

Filename for tftp software update. A minimum of length of 25
characters must be supported. Server is defined in genchass.mib

A set command will initiate tftp download.
Get has no meaning and will always return 1.

A progress indication during download which can be polled.

The time (in hundredths of a second) since the
card was powered up. This is comparable to the
mib-2.system.sysUpTime timer object for the IP
addressable agent, but is unique for each card.

The Adtran Product Name

The Adtran Product Part Number

The Adtran Product CLEI Code

The Adtran Product Serial Number

The Adtran Product Revision Number

The Adtran Product Software Version Number

This octet string variable is the same as the ifPhysAddress
in IF-MIB. THe SCU will report MAC address, else 0 for other cards.

The Adtran Product ID equivalent to sysObjectID

The data transmission circuit/facility/payload level of the
device (see Appendix A of GR-833-CORE). Common examples are:
T0, T1, T2, T3, STS1, and OC3. For the SCU and other common
equipment cards, the code should be E…

Allows forcing slot with adGenAccessoryState of virtual state to empty.
adGenAccessoryStateConfig will only accept a value Empty(1).