zhnPwAdaptPllMode
ZHNPWMIB ·
.1.3.6.1.4.1.5504.2.5.31.1.3
Object
scalar
r/w
Enumeration
Configure the accuracy of the recovered clock for all Pseudo-wire connections. Note, configuration must be saved and system rebooted for this item to take effect. When set to normal(1), the system will support reliable timing recovery in networks with occasional packet delay variation and packet loss. This is the recommended mode of operation. When set to fine(2), the accuracy of the recovered clock will be slightly higher than normal(1) mode, but during the clock recovery phase the network must be stable and predictable and requires pristine network conditions during timing acquisition.
Context
- MIB
- ZHNPWMIB
- OID
.1.3.6.1.4.1.5504.2.5.31.1.3- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- zhnPwObjects
- Siblings
- 12
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | normal |
2 | fine |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| zhnPwTable This table contains the Zhone Proprietary
Pseudo-Wire interface information. | table | - | .1.3.6.1.4.1.5504.2.5.31.1.1 |
| zhnPwT1E1Mode This object identifies the DS1 mode of operation for all DS1 ports in
the system. | scalar | Enumeration | .1.3.6.1.4.1.5504.2.5.31.1.10 |
| zhnPeerPingName This object identifies the name of the peer Pseudo Wire connection with
which to initiate a ping test. | scalar | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.5504.2.5.31.1.11 |
| zhnPeerPingRequest This object starts or stops a Pseudo Wire ping test. A valid zhnPeerPingName
must be configured for the ping test to be successful. | scalar | Enumeration | .1.3.6.1.4.1.5504.2.5.31.1.12 |
| zhnPeerPingStatus This object retrieves the status of the current or last Pseudo Wire ping
test initiated by the CPE. | scalar | Enumeration | .1.3.6.1.4.1.5504.2.5.31.1.13 |
| zhnPwRtpHeaderMode Enable or disable the transmission of a RTP header mode for all
Pseudo-wire connections. Note, the configuration must be saved and
the system rebooted for this item to take eff… | scalar | Enumeration | .1.3.6.1.4.1.5504.2.5.31.1.2 |
| zhnPwAutoAdclEnable Enable or disable the ability to automatically select the first available
Pseudo Wire connection to use for adaptive clock recovery. | scalar | Enumeration | .1.3.6.1.4.1.5504.2.5.31.1.4 |
| zhnPwAdaptSourceActual The actual Pseudo Wire connection in use for adaptive clock recovery
if automatic adaptive is disabled. | scalar | SNMPv2-TCDisplayString | .1.3.6.1.4.1.5504.2.5.31.1.5 |
| zhnPwSourceIPAddr This object contains the IP address for all local Pseudo Wire connections. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.5504.2.5.31.1.6 |
| zhnPwSourceIPMask This object contains the subnet mask for all local Pseudo Wire connections. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.5504.2.5.31.1.7 |
| zhnPwSourceGateway This object contains the gateway address for all local Pseudo Wire connections. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.5504.2.5.31.1.8 |
| zhnPwUdpDstPort This object contains the UDP port used by the peer. | scalar | Unsigned32 | .1.3.6.1.4.1.5504.2.5.31.1.9 |