zbrWLanCcxLinkTest

Enable/disable the link test feature. With the CCX link test, the controller can also test the link quality in the access point-to-client direction.
The controller issues link-test requests to the client, and the client records the RF parameters [received signal strength indicator (RSSI),
signal-to-noise ratio (SNR), etc.] of the received request packet in the response packet. Both the link-test requestor and responder roles are implemented
on the access point and controller. Therefore, not only can the access point or controller initiate a link test to a CCX v4 client, but a CCX v4 client can
initiate a link test to the access point or controller. The controller shows these link-quality metrics for CCX link tests in both directions (out: access
point to client; in: client to access point): Signal strength in the form of RSSI (minimum, maximum, and average), Signal quality in the form of SNR (minimum,
maximum, and average), Total number of packets that are retried, Maximum retry count for a single packet, Number of lost packets, Data rate of a successfully
transmitted packet. The controller shows this metric regardless of direction: Link test request/reply round-trip time (minimum, maximum, and average). The 4.0
release of controller software supports CCX versions 1 through 4. CCX support is enabled automatically for every WLAN on the controller and cannot be disabled.
The controller stores the CCX version of the client in its client database and uses it to limit the features for this client. If a client does not support CCX
v4, the controller performs a ping link test on the client. If a client supports CCX v4, the controller performs a CCX link test on the client. If a client
times out during a CCX link test, the controller switches to the ping link test automatically.

MIB

ZEBRA-MIB

OID

.1.3.6.1.4.1.10642.20.6.20.6

Type

scalar

Access

readwrite

Status

current

Parent

zbrWLanCcx