xfTermCapacity

This object sets the capacity on the terminal
* other        - Unknown
* twoE1        - 2x2 Mbps
* fourE1       - 4*2 Mbps (only rlMLE)
* oneE2        - 8 Mbps
* twoE2        - 2x8 Mbps
* oneE3oneE1   - 34+2 Mbps
* twoE3        - 2x34 Mbps
* fourE3       - 4*34 Mbps
* fourDS1      - 4xDS1
* eightDS1     - 8xDS1
* sixteenDS1   - 16*DS1
* seventeenDS1 - 16DS1+DS1
* oneStm0      - STM-0
* oneStm1oneE1 - STM-1+2
* thirtytwoDS1 - 32xDS1
* oneStm1oneDS1 - STM-1+DS1
* oneStm1oneE1at50MHz - STM-1+2 Mpbs @ 50 MHz
* twentytwoE1   - 22xE1
* thirtyfiveE1  - 35xE1
* fortysixE1    - 46xE1
* seventyfiveE1 - 75xE1
* oneStm1OneJ1  - 1xSTM-1 + 1xJ1
* sixtynineDS1  - 69xDS1
* eightyDS1     - 80xDS1
* oneStm1OneE1LH  - STM-1+2 for LH
* oneStm1OneDS1LH - STM-1+DS1 for LH
              
Default value PDH CQPSK ETSI: twoE1(2)            MMU2, MMU2 B, MMU2 C
Default value PDH CQPSK ANSI: fourDS1(9)          MMU2 BA, MMU2 CA
Default value PDH QAM   ETSI: twentytwoE1(18)     MMU2 D
Default value PDH QAM   ANSI: sixtynineDS1(23)    MMU2 DA
Default value SDH       ETSI: oneStm1oneE1(14)    MMU2 E, MMU2 F
Default value SDH       ANSI: oneStm1oneDS1(16)   MMU2 E, MMU2 F
              
Near end access: read-write
Far end access: read-write (Traffic Node), read-only (MLE)
              
Note that setting far end xfTermCapacity will remove far end traffic cross connects.
              
oneStm1oneE1(14) and oneStm1oneE1at50MHz(17) has
the same capacity and modulation but at different
bandwidth, hence the two values.
              
Capacities above 2xE1 for MMU2 B OFH, MMU2 C OFH,
ATU and ATU B OFH are under license control.

MIB

XF-RADIOLINK-PTP-TERMINAL-MIB

OID

.1.3.6.1.4.1.193.81.3.4.1.1.1.1.4

Type

column

Access

readwrite

Status

current

Parent

xfRLPtpTerminalEntry

Groups

1