cfgWlanDevBandwidth

Wireless Bandwidth Mode specifies the Bandwidth of the Channel.
              
* **bw20(0):** for 20MHz wide channel.
* **bw40Plus(1):** for 40MHz wide channel with the side
  channel on the top.
* **bw40Minus(2):** for 40MHz wide channel with the side
  channel on the bottom.
* **bwQuarter(3):** for 5MHz wide channel (quarter rate).
* **bwHalf(4):** for 10MHz wide channel (half rate).
* **bw80(5):** 80MHz wide channel (only in 11ac mode)
* **bw160(6):** 160MHz wide channel (only in 11ac mode)
* **bw8080(7):** 80+80MHz wide channel (only in 11ac mode)
* **bwAuto(8):** automatic channel width (only in 11ac mode)
              
**Note:** **bw40Plus(1)** and **bw40Minus(2)** may not be
          usable on all channels.
              
**Examples**
              
The following table shows examples of which channels may be used.
The full list can be found in IEEE 802.11n Annex J. Depending on
the country, not all frequencies may be available.
              
| Band       | **bw40Plus(1)**         | **bw40Minus(2)**       |
|------------|-------------------------|------------------------|
| 2.4 GHz    | 2412 to 2452            | 2432 to 2472           |
| 5 GHz      | 5180, 5220, 5260, etc.  | 5200, 5240, 5280, etc. |
              
**Note:** Some products do not support all bandwidths.
Please check the data-sheet of your product.
              
Applies to AP and STA.

MIB

WESTERMO-SW6-MIB

OID

.1.3.6.1.4.1.16177.1.400.1.1.3.1.1.5

Type

column

Access

readwrite

Status

current

Parent

cfgWlanDeviceTableEntry