saCmForceDualscan

The MIB will choose whether to force dualscan
operation for the device.  Dualscan refers to the
CM ability to automatically scan for both 6MHz and
8MHz carriers.
0 : Will not force dualscan.  In this case, the 
    factory configuration for dualscan will take 
    effect.
    *note: Factory Dualscan configuration is 
     typically only enabled for EPC products.
1 : Will force dualscan to be enabled.  In this 
    case, dualscan will be enabled regardless of 
    the factory setting.
This MIB value will be stored to NonVolatile
memory(NVM) and will persist across reboots.  If 
the MIB is set via the config file, the CM will 
store the new setting and begin using it on next
reboot.  Removing the setting from the config 
file will not change the value stored in NVM the 
CM will continue to operate using the previously 
stored value.
However, if an SNMP SET is used to modify the 
value, then the CM will not use the new setting 
until the next reboot occurs or is commanded.
A factory reset of the CM will set the stored
value back to 0.
 2 : *Docsis1 mode will only allow the modem to lock Annex B (6MHz) channels and will ignore all Annex 	 A (8MHz) channels.
 3 : *EuroDocsis mode will only allow the modem to lock Annex A (8MHz) channesl and will ignore all    	 Annex B (6 MHz)channels.
 *Feature available upon request for dualscan capable modems.

MIB

SA-CM-MIB

OID

.1.3.6.1.4.1.1429.77.1.4.14

Type

scalar

Access

readwrite

Status

current

Parent

cmInterfaceInfo