prtIpParamRingMode
RAD-GEN-MIB ·
.1.3.6.1.4.1.164.6.2.15.6.1.1.12
Object
column
r/w
Enumeration
This object indicates If Ring Mode is enabled or not.
Context
- MIB
- RAD-GEN-MIB
- OID
.1.3.6.1.4.1.164.6.2.15.6.1.1.12- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- prtIpParamEntry
- Table
- prtIpParamTable
- Siblings
- 37
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | notApplicable |
2 | disable |
3 | enable |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| prtIpParamConfigIdx This object indicates the Configuration number (1..255)
referred.
Value of 255 specifies the TmpCnfg (Scratch).
For products having Agent and Edit configurations,
Write operatio… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.1 |
| prtIpParamMngVlanId Management VLAN ID. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.10 |
| prtIpParamMngVlanPriority Management VLAN Frame priority. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.11 |
| prtIpParamProtIpEnable This object indicates whether a list of Protected IP Addresses
is enabled or not. This object is applicable only if
prtIpParamRingMode=enable. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.13 |
| prtIpParamTrafficPriority This object indicates the traffic priority of this port. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.14 |
| prtIpParamRemoteIP This is the IP Address of the remote device that is connected to the
current device (Point to Point Application). It is used for sending OAM packets
on the LAN to the remote side … | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.6.2.15.6.1.1.15 |
| prtIpParamMaxTxBandwidth This object shows the Max Bandwidth allowed on the LAN.
Full - means that a Maximum of 100 Mega Byte Rate may go through the LAN.
e1(3) means that the maximum is an E1 rate. t1(… | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.16 |
| prtIpParamTos TOS = Type of Service transmitted.
Valid values: 0..255. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.17 |
| prtIpParamConnect Port Connection. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.18 |
| prtIpParamAgingTime Aging Time in seconds. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.19 |
| prtIpParamSlotIdx This object indicates a unique number of the slot position
in which the module is inserted.
notApplicable = 255 (for products that don't have slots).
For KM:
kmx… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.2 |
| prtIpParamEncapsulationProt Encapsulation Protocol. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.20 |
| prtIpParamEncapProtPort Encapsulation Protocol Port (TCP/UDP Port). | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.21 |
| prtIpParamVlanSupport VLAN support (Tagging).
'no' - No support of VLAN Tagging.
'yes' - 4 VLAN bytes will be added to the frame. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.22 |
| prtIpParamVlanId VLAN Identifier. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.23 |
| prtIpParamVlanPriority VLAN Frame priority. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.24 |
| prtIpParamDoubleTagVlanId VLAN Identifier of the Double Tagging VLAN. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.25 |
| prtIpParamDoubleTagVlanPriority VLAN Frame priority of the Double Tagging VLAN. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.26 |
| prtIpParamVlanTagging VLAN Tagging.
'unmodified' - No change will be done to the Frame.
'tag' - Add Tag to Untagged Frames.
'doubleTag' - Add Tag to all Frames.
'doubleTagAndFallBack' - Double Tagging … | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.27 |
| prtIpParamRateLimit The maximum rate permitted to transfer via this port, in Kbps. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.28 |
| prtIpParamDefInterface The Default Interface for packets with unresolved destination subnet.
For internal-X port: 100 + X . | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.29 |
| prtIpParamIdx This object indicates a unique Port Index. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.3 |
| prtIpParamMng This object indicates whether Management is enabled/disabled
via this port. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.30 |
| prtIpParamFloodedRateLimit The maximum rate permitted to transfer broadcast, multicast,
and unicast flooded frames via this port, in Kbps.
0 - Disable.
In Ipmux14 this parameter is applicable when prtIpPara… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.31 |
| prtIpParamBurstSize The burst size that the port can support beyond rate limitation
determined in prtIpParamRateLimit.
Burst Size is measured in bytes. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.32 |
| prtIpParamLimitPacketType The packet type that will be rate limited. Rate limitation
determined in prtIpParamRateLimit.
all - All packet types are rate limited.
broadMultiFloodedUnicast - Broadcast, Mul… | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.33 |
| prtIpParamKeepAliveInterval This parameter indicates the period of time (in msec.)
between two consequent Keep Alive messages. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.34 |
| prtIpParamKeepAliveThresh This parameter indicates the maximum number of
missed Keep Alive answer messages acceptable, after which link status will be failed. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.35 |
| prtIpParamP2pKeepAliveVlanId Dedicated VLAN ID for keep alive messages. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.36 |
| prtIpParamP2pKeepAliveVlanPrio VLAN priority for P2P keep alive messages . | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.15.6.1.1.37 |
| prtIpParamRingAdjacentMacAddr The MAC address of the adjacent NE connected to this port in an ETH ring.
If the port is not a member of a ring, the value of this parameter
will be 00-00-00-00-00-00. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.164.6.2.15.6.1.1.38 |
| prtIpParamHostIP The host interface IP address. | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.6.2.15.6.1.1.4 |
| prtIpParamHostMask The host interface subnet mask. | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.6.2.15.6.1.1.5 |
| prtIpParamDefaultGateway Default Gateway's IP Address. | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.6.2.15.6.1.1.6 |
| prtIpParamMediaMode This object indicates the real Media Mode. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.7 |
| prtIpParamMediaRate This object indicates the real Media Rate (Mbps). | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.8 |
| prtIpParamMngVlanSupport Management VLAN support (Tagging).
no - No support of VLAN Tagging.
yes - 4 VLAN bytes will be added to the frame. | column | Enumeration | .1.3.6.1.4.1.164.6.2.15.6.1.1.9 |