prtIpParamFloodedRateLimit

RAD-GEN-MIB · .1.3.6.1.4.1.164.6.2.15.6.1.1.31
MIB view Table view

Object

column r/w SNMPv2-SMIInteger32 
The maximum rate permitted to transfer broadcast, multicast,
and unicast flooded frames via this port, in Kbps.
0 - Disable.
In Ipmux14 this parameter is applicable when prtIpParamRateLimit=0 (disable).

Context

MIB
RAD-GEN-MIB
OID
.1.3.6.1.4.1.164.6.2.15.6.1.1.31
Type
column
Access
readwrite
Status
current
Parent
prtIpParamEntry
Table
prtIpParamTable
Siblings
37

Syntax

SNMPv2-SMIInteger32
Source
SNMPv2-SMIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
prtIpParamConfigIdx
This object indicates the Configuration number (1..255) referred. Value of 255 specifies the TmpCnfg (Scratch). For products having Agent and Edit configurations, Write operatio…
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.1
prtIpParamMngVlanId
Management VLAN ID.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.10
prtIpParamMngVlanPriority
Management VLAN Frame priority.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.11
prtIpParamRingMode
This object indicates If Ring Mode is enabled or not.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.12
prtIpParamProtIpEnable
This object indicates whether a list of Protected IP Addresses is enabled or not. This object is applicable only if prtIpParamRingMode=enable.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.13
prtIpParamTrafficPriority
This object indicates the traffic priority of this port.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.14
prtIpParamRemoteIP
This is the IP Address of the remote device that is connected to the current device (Point to Point Application). It is used for sending OAM packets on the LAN to the remote side …
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.164.6.2.15.6.1.1.15
prtIpParamMaxTxBandwidth
This object shows the Max Bandwidth allowed on the LAN. Full - means that a Maximum of 100 Mega Byte Rate may go through the LAN. e1(3) means that the maximum is an E1 rate. t1(…
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.16
prtIpParamTos
TOS = Type of Service transmitted. Valid values: 0..255.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.17
prtIpParamConnect
Port Connection.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.18
prtIpParamAgingTime
Aging Time in seconds.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.19
prtIpParamSlotIdx
This object indicates a unique number of the slot position in which the module is inserted. notApplicable = 255 (for products that don't have slots). For KM: kmx…
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.2
prtIpParamEncapsulationProt
Encapsulation Protocol.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.20
prtIpParamEncapProtPort
Encapsulation Protocol Port (TCP/UDP Port).
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.21
prtIpParamVlanSupport
VLAN support (Tagging). 'no' - No support of VLAN Tagging. 'yes' - 4 VLAN bytes will be added to the frame.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.22
prtIpParamVlanId
VLAN Identifier.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.23
prtIpParamVlanPriority
VLAN Frame priority.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.24
prtIpParamDoubleTagVlanId
VLAN Identifier of the Double Tagging VLAN.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.25
prtIpParamDoubleTagVlanPriority
VLAN Frame priority of the Double Tagging VLAN.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.26
prtIpParamVlanTagging
VLAN Tagging. 'unmodified' - No change will be done to the Frame. 'tag' - Add Tag to Untagged Frames. 'doubleTag' - Add Tag to all Frames. 'doubleTagAndFallBack' - Double Tagging …
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.27
prtIpParamRateLimit
The maximum rate permitted to transfer via this port, in Kbps.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.28
prtIpParamDefInterface
The Default Interface for packets with unresolved destination subnet. For internal-X port: 100 + X .
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.29
prtIpParamIdx
This object indicates a unique Port Index.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.3
prtIpParamMng
This object indicates whether Management is enabled/disabled via this port.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.30
prtIpParamBurstSize
The burst size that the port can support beyond rate limitation determined in prtIpParamRateLimit. Burst Size is measured in bytes.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.164.6.2.15.6.1.1.32
prtIpParamLimitPacketType
The packet type that will be rate limited. Rate limitation determined in prtIpParamRateLimit. all - All packet types are rate limited. broadMultiFloodedUnicast - Broadcast, Mul…
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.33
prtIpParamKeepAliveInterval
This parameter indicates the period of time (in msec.) between two consequent Keep Alive messages.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.34
prtIpParamKeepAliveThresh
This parameter indicates the maximum number of missed Keep Alive answer messages acceptable, after which link status will be failed.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.35
prtIpParamP2pKeepAliveVlanId
Dedicated VLAN ID for keep alive messages.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.36
prtIpParamP2pKeepAliveVlanPrio
VLAN priority for P2P keep alive messages .
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.164.6.2.15.6.1.1.37
prtIpParamRingAdjacentMacAddr
The MAC address of the adjacent NE connected to this port in an ETH ring. If the port is not a member of a ring, the value of this parameter will be 00-00-00-00-00-00.
columnSNMPv2-TCMacAddress.1.3.6.1.4.1.164.6.2.15.6.1.1.38
prtIpParamHostIP
The host interface IP address.
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.164.6.2.15.6.1.1.4
prtIpParamHostMask
The host interface subnet mask.
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.164.6.2.15.6.1.1.5
prtIpParamDefaultGateway
Default Gateway's IP Address.
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.164.6.2.15.6.1.1.6
prtIpParamMediaMode
This object indicates the real Media Mode.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.7
prtIpParamMediaRate
This object indicates the real Media Rate (Mbps).
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.8
prtIpParamMngVlanSupport
Management VLAN support (Tagging). no - No support of VLAN Tagging. yes - 4 VLAN bytes will be added to the frame.
columnEnumeration.1.3.6.1.4.1.164.6.2.15.6.1.1.9