pktcSigPulseSignalDbLevel
PKTC-IETF-SIG-MIB ·
.1.3.6.1.2.1.169.1.1.20.1.3
Object
column
r/w
1/10 of a dBm Integer32
This object is only applicable to the enableMeterPulse and meterPulseBurst signal types. This is the decibel level for each frequency at which tones could be generated at the a and b terminals (TE connection point). An attempt to set this object while the value of pktcSigPulseSignalType is not enableMeterPulse or meterPulseBurst will result in an 'inconsistentValue' error.
Context
- MIB
- PKTC-IETF-SIG-MIB
- OID
.1.3.6.1.2.1.169.1.1.20.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Units
- 1/10 of a dBm
- Parent
- pktcSigPulseSignalEntry
- Table
- pktcSigPulseSignalTable
- Siblings
- 5
Syntax
1/10 of a dBm Integer32
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pktcSigPulseSignalType There are nine types of international pulse signals. These
signals are defined as follows:
initial ring
pulse loop close
pulse loop open
enable meter pulse
meter pulse burst
puls… | column | Enumeration | .1.3.6.1.2.1.169.1.1.20.1.1 |
| pktcSigPulseSignalFrequency This object is only applicable to the initialRing,
enableMeterPulse, and meterPulseBurst signal types. This
object identifies the frequency of the generated signal.
The following… | column | Enumeration | .1.3.6.1.2.1.169.1.1.20.1.2 |
| pktcSigPulseSignalDuration This object specifies the pulse duration for each
signal type. In addition, the MTA must accept the values
in the incremental steps specific for each signal type.
The following t… | column | Milliseconds Unsigned32 | .1.3.6.1.2.1.169.1.1.20.1.4 |
| pktcSigPulseSignalPulseInterval This object specifies the repeat interval, or the period,
for each signal type. In addition, the MTA must accept
the values in the incremental steps specific for each
signal type… | column | Milliseconds Unsigned32 | .1.3.6.1.2.1.169.1.1.20.1.5 |
| pktcSigPulseSignalRepeatCount This object specifies how many times to repeat a pulse.
This object is not used by the enableMeterPulse signal
type, and in that case, the value is irrelevant. The
following tabl… | column | Unsigned32 | .1.3.6.1.2.1.169.1.1.20.1.6 |