pktcSigPulseSignalType
PKTC-EXCENTIS-SIG-MIB ·
.1.3.6.1.4.1.7432.2.1.1.20.1.1
Object
column
Enumeration
There are nine types of international pulse signals. These signals are defined as follows: initial ring pulse loop close pulse loop open enable meter pulse meter pulse burst pulse no battery pulse normal polarity pulse reduced battery pulse reverse polarity
Context
- MIB
- PKTC-EXCENTIS-SIG-MIB
- OID
.1.3.6.1.4.1.7432.2.1.1.20.1.1- Type
- column
- Access
- noaccess
- Status
- current
- Parent
- pktcSigPulseSignalEntry
- Table
- pktcSigPulseSignalTable
- Siblings
- 5
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | initialRing |
2 | pulseLoopClose |
3 | pulseLoopOpen |
4 | enableMeterPulse |
5 | meterPulseBurst |
6 | pulseNoBattery |
7 | pulseNormalPolarity |
8 | pulseReducedBattery |
9 | pulseReversePolarity |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pktcSigPulseSignalFrequency This object is only applicable to the initialRing,
enableMeterPulse, and meterPulseBurst signal type. This
object identifies the frequency of the generated signal.
The followin… | column | Hertz Enumeration | .1.3.6.1.4.1.7432.2.1.1.20.1.2 |
| pktcSigPulseSignalDbLevel This object is only applicable to the enableMeterPulse and
meterPulseBurst signal types. This is the decibel level
for each frequency at which tones could be generated at
the a… | column | dBm Integer32 | .1.3.6.1.4.1.7432.2.1.1.20.1.3 |
| pktcSigPulseSignalDuration This object specifies the pulse duration for each
signal type. In addition, the MTA must accept the values
in the incremental steps specific for each signal type.
The following… | column | Milliseconds Unsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.4 |
| pktcSigPulseSignalPulseInterval This object specifies the repeat interval, or the period
for each signal type. In addition, the MTA must accept
the values in the incremental steps specific for each
signal typ… | column | Milliseconds Unsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.5 |
| pktcSigPulseSignalRepeatCount This object specifies how many times to repeat a pulse.
This object is not used by the enableMeterPulse signal
type and as such must have a value o… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.6 |