pktcSigPulseSignalPulseInterval

PKTC-EXCENTIS-SIG-MIB · .1.3.6.1.4.1.7432.2.1.1.20.1.5

Object

column r/w Milliseconds Unsigned32

This object specifies the repeat interval, or the period 
for each signal type. In addition, the MTA must accept 
the values in the incremental steps specific for each 
signal type. The following table defines the default 
values and the incremental steps for this object depending 
on the signal type. 
pktcSigPulseSignaltype  Default (ms)   Increment (ms) 
initialRing                 200             50 
pulseLoopClose             1000             10 
pulseLoopOpen              1000             10 
enableMeterPulse           1000             10 
meterPulseBurst            1000             10 
pulseNoBattery             1000             10 
pulseNormalPolarity        1000             10 
pulseReducedBattery        1000             10 
pulseReversePolarity       1000             10 
An attempt to set this object to a value that does not 
fall on one of the increment boundaries, or on the wrong 
increment boundary for the specific signal type will 
result in an 'inconsistent value' error.

Context

MIB: PKTC-EXCENTIS-SIG-MIB
OID: .1.3.6.1.4.1.7432.2.1.1.20.1.5
Type: column
Access: readwrite
Status: current
Units: Milliseconds
Parent: pktcSigPulseSignalEntry
Table: pktcSigPulseSignalTable
Siblings: 5

Syntax

Milliseconds Unsigned32

Values & Constraints

Object Constraints

range: 0-5000

Related Objects

Sibling Objects

Object	Type	Syntax	OID
pktcSigPulseSignalType There are nine types of international pulse signals. These signals are defined as follows: initial ring pulse loop close pulse loop open enable meter pulse meter pulse burst…	column	Enumeration	`.1.3.6.1.4.1.7432.2.1.1.20.1.1`
pktcSigPulseSignalFrequency This object is only applicable to the initialRing, enableMeterPulse, and meterPulseBurst signal type. This object identifies the frequency of the generated signal. The followin…	column	Hertz Enumeration	`.1.3.6.1.4.1.7432.2.1.1.20.1.2`
pktcSigPulseSignalDbLevel This object is only applicable to the enableMeterPulse and meterPulseBurst signal types. This is the decibel level for each frequency at which tones could be generated at the a…	column	dBm Integer32	`.1.3.6.1.4.1.7432.2.1.1.20.1.3`
pktcSigPulseSignalDuration This object specifies the pulse duration for each signal type. In addition, the MTA must accept the values in the incremental steps specific for each signal type. The following…	column	Milliseconds Unsigned32	`.1.3.6.1.4.1.7432.2.1.1.20.1.4`
pktcSigPulseSignalRepeatCount This object specifies how many times to repeat a pulse. This object is not used by the enableMeterPulse signal type and as such must have a value o…	column	SNMPv2-SMIUnsigned32	`.1.3.6.1.4.1.7432.2.1.1.20.1.6`