pktcSigPulseSignalFrequency
PKTC-EXCENTIS-SIG-MIB ·
.1.3.6.1.4.1.7432.2.1.1.20.1.2
Object
column
r/w
Hertz Enumeration
This object is only applicable to the initialRing,
enableMeterPulse, and meterPulseBurst signal type. This
object identifies the frequency of the generated signal.
The following table defines the default values for this
object depending on signal type:
pktcSigPulseSignalType Default
initialRing 25
enableMeterPulse 16000
meterPulseBurst 16000
The value of twentyfive MUST only be used for the
initialRing signal type. The values of twelvethousand and
sixteenthousand MUST only be used for enableMeterPulse and
meterPulseBurst signal types. An attempt to set this
object while the value of pktcSigPulseSignalType is not
initialRing,enableMeterPulse, or meterPulseBurst will
result in an 'inconsistent value' error.
Context
- MIB
- PKTC-EXCENTIS-SIG-MIB
- OID
.1.3.6.1.4.1.7432.2.1.1.20.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Units
- Hertz
- Parent
- pktcSigPulseSignalEntry
- Table
- pktcSigPulseSignalTable
- Siblings
- 5
Syntax
Hertz Enumeration
Values & Constraints
Enumerated Values
1 | twentyfive |
2 | twelvethousand |
3 | sixteenthousand |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pktcSigPulseSignalType There are nine types of international pulse signals. These
signals are defined as follows:
initial ring
pulse loop close
pulse loop open
enable meter pulse
meter pulse burst… | column | Enumeration | .1.3.6.1.4.1.7432.2.1.1.20.1.1 |
| pktcSigPulseSignalDbLevel This object is only applicable to the enableMeterPulse and
meterPulseBurst signal types. This is the decibel level
for each frequency at which tones could be generated at
the a… | column | dBm Integer32 | .1.3.6.1.4.1.7432.2.1.1.20.1.3 |
| pktcSigPulseSignalDuration This object specifies the pulse duration for each
signal type. In addition, the MTA must accept the values
in the incremental steps specific for each signal type.
The following… | column | Milliseconds Unsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.4 |
| pktcSigPulseSignalPulseInterval This object specifies the repeat interval, or the period
for each signal type. In addition, the MTA must accept
the values in the incremental steps specific for each
signal typ… | column | Milliseconds Unsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.5 |
| pktcSigPulseSignalRepeatCount This object specifies how many times to repeat a pulse.
This object is not used by the enableMeterPulse signal
type and as such must have a value o… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.7432.2.1.1.20.1.6 |