pktcSigDevToneSteady

This is the steady tone. Device must play out the on-off 
cadence sequence for pktcSigDevToneWholeRepeatCount times 
and 
then apply the last tone forever. Setting this object 
may result in a tone duration longer or shorter than the 
overall signal duration specified by the time out (TO) 
object for a particular signal. If the repeat count results 
in a longer tone duration than the signal duration 
specified by the TO, the tone duration defined 
by the TO object for a particular signal always represents 
the overall signal duration for a tone. In this case, the 
tone duration repeat count will not be fully exercised and 
the desired tone duration will be truncated per the TO 
setting. If the repeat count results in a shorter tone 
duration than the signal duration specified by the TO, the 
tone duration defined by the repeat count takes precedence 
over the TO and will end the signal event. In this case, 
the TO represents a time not to be exceeded for the signal. 
It is recommended to ensure proper telephony signaling that 
The TO duration setting should always be longer than the 
desired repeat count time duration plus the desired maximum 
steady tone period.

MIB

PKTC-EXCENTIS-SIG-MIB

OID

.1.3.6.1.4.1.7432.2.1.1.32.1.3

Type

column

Access

readwrite

Status

current

Parent

pktcSigDevToneEntry