epSpecificJitterBufferCustomNomLength

Endpoint Specific Custom Jitter Buffer Nominal Length
              
The jitter buffer nominal length (in milliseconds) is the
delay the jitter buffer uses when a call begins. The delay
then varies according to network conditions.
              
If this parameter is set to 0, the nominal jitter is set to
(minimal jitter buffer + maximal jitter buffer) / 2.
              
The nominal jitter buffer MUST be equal to or smaller than
the maximal jitter buffer.
              
The nominal jitter buffer should be a multiple of ptime.
              
This value is used only when the Level parameter is set to
'Custom'.
              
The maximum allowed value for this parameter is platform
dependent.
              
If this value is smaller than the value set in the
EpSpecificJitterBuffer.CustomMinLength parameter, it will be
accepted, however the value set in the
EpSpecificJitterBuffer.CustomMinLength parameter will instead
be used.
              
This configuration overrides the default configuration set in
the DefaultJitterBufferCustomNomLength parameter if the
EpSpecificJitterBuffer.EnableConfig parameter is set to
'Enable'.

MIB

MX-MIPT-MIB

OID

.0.1600.1.200.400.1.410

Type

column

Access

readwrite

Status

current

Parent

epSpecificJitterBufferEntry