defaultCodecClearModeDataEnable

Default Clear Mode Enable/Disable Configuration for Data
          
If enabled, the Clear Mode protocol is used for data
transmission.
          
The data transmission for this codec can be triggered by the
detection of a fax/modem tone or if the properties of the call
indicate that it was for data.
          
Clear Mode is a method to carry 64 kbit/s channel data
transparently in RTP packets as defined in RFC 4040.
          
This codec always uses the RTP transport.
          
If a specific value is set for the
EpSpecificCodecClearMode.DataEnable parameter and the
EpSpecificCodecClearMode.EnableConfig parameter is set to
'Enable', then the specific value will override the current
default value.

MIB

MX-MIPT-MIB

OID

.0.1600.1.100.800.300

Type

scalar

Access

readwrite

Status

current

Parent

codecClearModeGroup