wdmCtrlChannelStartupChannel

Initiates a safe startup procedure for the channel
when set to 'start'.
              
If the administrative status of the channel is
'down' or the channel is not detected by the monitor
unit, the system attempts to detect the channel as
follows:
              
1) The attenuation is set to its maximum value.
              
2) The attenuation is decreased until the channel is
detected by the monitor.
              
When the channel is detected, regulation of the
channel is started, ignoring the regulation range.
              
If the channel cannot be detected, channelStatus is
set to notFound. If regulation in fails,
channelStatus is set to error and an alarm is
raised.
              
When the startup sequence is finished, the
administrative status of the channel is set to 'up'.
              
If a regulation is ongoing when the startup
procedure is initiated, the channel is put on a
waiting queue until the ongoing regulation is
finished. The startup queue has a limited length. If
the queue is filled up with waiting channels,
further startup commands will be blocked until all
the queued channels have been started.
              
At times when it is not allowed to start the
channel, e.g. in commissioning mode or when the
queue is full, this attribute is set to 'blocked'
and cannot be set to start.
              
NOTE: The 'blocked' state is handled entirely by the
system and cannot be set or reset by the user.
              
The state of this attribute immediately returns to
'normal' when the startup procedure has been
initiated or the channel is put on the startup
queue.

MIB

LUM-WDM-MIB

OID

.1.3.6.1.4.1.8708.2.4.2.8.1.1.17

Type

column

Access

readwrite

Status

current

Parent

wdmCtrlChannelEntry