intSrvFlowDestPort
INT-SERV-MIB ·
.1.3.6.1.2.1.52.1.2.1.9
Object
column
r/w
Port
The UDP or TCP port number used as a destina- tion port for all senders in this session. If the IP protocol in use, specified by intSrvResvFwdProtocol, is 50 (ESP) or 51 (AH), this represents a virtual destination port number. A value of zero indicates that the IP protocol in use does not have ports. This ob- ject may not be changed when the value of the RowStatus object is 'active'.
Context
- MIB
- INT-SERV-MIB
- OID
.1.3.6.1.2.1.52.1.2.1.9- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- intSrvFlowEntry
- Table
- intSrvFlowTable
- Siblings
- 24
Syntax
Port
- Source
- Port
- Base type
OctetString
Values & Constraints
Type Constraints
range: 2..4
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| intSrvFlowNumber The number of this flow. This is for SNMP In-
dexing purposes only and has no relation to any
protocol value. | column | SessionNumber | .1.3.6.1.2.1.52.1.2.1.1 |
| intSrvFlowPort The UDP or TCP port number used as a source
port for this sender in this session. If the
IP protocol in use, specified by
intSrvResvFwdProtocol is 50 (ESP) … | column | Port | .1.3.6.1.2.1.52.1.2.1.10 |
| intSrvFlowFlowId The flow ID that this sender is using, if
this is an IPv6 session. | column | Integer32 | .1.3.6.1.2.1.52.1.2.1.11 |
| intSrvFlowInterface The ifIndex value of the interface on which
this reservation exists. | column | IF-MIBInterfaceIndex | .1.3.6.1.2.1.52.1.2.1.12 |
| intSrvFlowIfAddr The IP Address on the ifEntry on which this
reservation exists. This is present primarily
to support those interfaces which layer multi-
ple IP Addresses on the interface. | column | OctetString | .1.3.6.1.2.1.52.1.2.1.13 |
| intSrvFlowRate The Reserved Rate of the sender's data stream.
If this is a Controlled Load service flow, this
rate is derived from the Tspec rate parameter
(r). If this is a Guaranteed se… | column | bits per second BitRate | .1.3.6.1.2.1.52.1.2.1.14 |
| intSrvFlowBurst The size of the largest burst expected from
the sender at a time.
If this is less than the sender's advertised
burst size, the receiver is asking the network… | column | bytes BurstSize | .1.3.6.1.2.1.52.1.2.1.15 |
| intSrvFlowWeight The weight used to prioritize the traffic.
Note that the interpretation of this object is
implementation-specific, as implementations
vary in their use of weighting proce… | column | SNMPv2-SMIInteger32 | .1.3.6.1.2.1.52.1.2.1.16 |
| intSrvFlowQueue The number of the queue used by this traffic.
Note that the interpretation of this object is
implementation-specific, as implementations
vary in their use of queue identifie… | column | SNMPv2-SMIInteger32 | .1.3.6.1.2.1.52.1.2.1.17 |
| intSrvFlowMinTU The minimum message size for this flow. The
policing algorithm will treat smaller messages
as though they are this size. | column | MessageSize | .1.3.6.1.2.1.52.1.2.1.18 |
| intSrvFlowMaxTU The maximum datagram size for this flow that
will conform to the traffic specification. This
value cannot exceed the MTU of the interface. | column | MessageSize | .1.3.6.1.2.1.52.1.2.1.19 |
| intSrvFlowType The type of session (IP4, IP6, IP6 with flow
information, etc). | column | SessionType | .1.3.6.1.2.1.52.1.2.1.2 |
| intSrvFlowBestEffort The number of packets that were remanded to
best effort service. | column | SNMPv2-SMICounter32 | .1.3.6.1.2.1.52.1.2.1.20 |
| intSrvFlowPoliced The number of packets policed since the incep-
tion of the flow's service. | column | SNMPv2-SMICounter32 | .1.3.6.1.2.1.52.1.2.1.21 |
| intSrvFlowDiscard If 'true', the flow is to incur loss when
traffic is policed. If 'false', policed traff-
ic is treated as best effort traffic. | column | SNMPv2-TCTruthValue | .1.3.6.1.2.1.52.1.2.1.22 |
| intSrvFlowService The QoS service being applied to this flow. | column | QosService | .1.3.6.1.2.1.52.1.2.1.23 |
| intSrvFlowOrder In the event of ambiguity, the order in which
the classifier should make its comparisons.
The row with intSrvFlowOrder=0 is tried first,
and comparisons proceed in the o… | column | Integer32 | .1.3.6.1.2.1.52.1.2.1.24 |
| intSrvFlowStatus 'active' for all active flows. This object
may be used to install static classifier infor-
mation, delete classifier information, or au-
thorize such. | column | SNMPv2-TCRowStatus | .1.3.6.1.2.1.52.1.2.1.25 |
| intSrvFlowOwner The process that installed this flow in the
queue policy database. | column | Enumeration | .1.3.6.1.2.1.52.1.2.1.3 |
| intSrvFlowDestAddr The destination address used by all senders in
this session. This object may not be changed
when the value of the RowStatus object is 'ac-
tive'. | column | OctetString | .1.3.6.1.2.1.52.1.2.1.4 |
| intSrvFlowSenderAddr The source address of the sender selected by
this reservation. The value of all zeroes in-
dicates 'all senders'. This object may not be
changed when the value of the RowSt… | column | OctetString | .1.3.6.1.2.1.52.1.2.1.5 |
| intSrvFlowDestAddrLength The length of the destination address in bits.
This is the CIDR Prefix Length, which for IP4
hosts and multicast addresses is 32 bits. This
object may not be changed when the v… | column | Integer32 | .1.3.6.1.2.1.52.1.2.1.6 |
| intSrvFlowSenderAddrLength The length of the sender's address in bits.
This is the CIDR Prefix Length, which for IP4
hosts and multicast addresses is 32 bits. This
object may not be changed when the v… | column | Integer32 | .1.3.6.1.2.1.52.1.2.1.7 |
| intSrvFlowProtocol The IP Protocol used by a session. This ob-
ject may not be changed when the value of the
RowStatus object is 'active'. | column | Protocol | .1.3.6.1.2.1.52.1.2.1.8 |