hwMplsPsSwitchCondition

The current switch condition of the protection group.
1: clear,This command clears all of the externally 
   initiated switch commands listed below;
2: lockout of protection,Fix the selector position on the 
   working LSP,Prevents the selector from switching to the 
   protection LSP when it is selecting the working LSP. 
   Switches the selector from the protection to the working LSP 
   when it is selecting the protection LSP;
3: forced protection,Switches the selector from the working LSP 
   to the protection LSP (unless a higher priority switch 
   request (i.e., LoP) is in effect);
4: signal fail,for 1:1,Signal Fail (SF) is declared when the 
   source of the protection domain enters the Defect State by 
   receiving a BDI packet (from the return LSP or out of band).
5: manual switch for working-lsp,Switches the selector from the 
   working LSP to the protection LSP (unless an equal or higher 
   priority switch request (i.e., LoP, FS, SF or MS) is in 
   effect);
6: manual switch for protection-lsp,Switches the selector from 
   the protection LSP to the working LSP (unless an equal or 
   higher priority switch request (i.e., LoP, FS, SF or MS) is 
   in effect).
7: WTR-timer;
8: HoldOff-timer;
9: Others;
The pripority of the commands are:
clear > lockout of protection > force switch > manual switch for working
lsp = manual switch for protection lsp

MIB

HUAWEI-MPLSOAM-MIB

OID

.1.3.6.1.4.1.2011.5.12.7.1.3.1.1.10

Type

column

Access

readonly

Status

current

Parent

hwMplsPsEntry

Table

hwMplsPsTable

Siblings

19