hwDot3ahEfmAdminState
HUAWEI-ETHOAM-MIB ·
.1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.1
Object
This object is used to provision the default administrative
OAM mode for this interface. This object represents the
desired state of OAM for this interface.
The hwDot3ahEfmAdminState always starts in the disabled(2) state
until an explicit management action or configuration
information retained by the system causes a transition to the
enabled(1) state. When enabled(1), Ethernet OAM will attempt
to operate over this interface.
Context
- MIB
- HUAWEI-ETHOAM-MIB
- OID
.1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.1- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- hwDot3ahEfmEntry
- Table
- hwDot3ahEfmTable
- Siblings
- 7
Syntax
P-BRIDGE-MIBEnabledStatus
- Source
- P-BRIDGE-MIBEnabledStatus
- Base type
Enumeration
Values & Constraints
Type Values
1 | enabled |
2 | disabled |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| hwDot3ahEfmOperStatus At initialization and failure conditions, two OAM entities on
the same full-duplex Ethernet link begin a discovery phase to
determine what OAM capabilities may be used on that lin… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.2 |
| hwDot3ahEfmMode This object configures the mode of OAM operation for this
Ethernet like interface. OAM on Ethernet interfaces may be in
'active' mode or 'passive' mode.
Options:
1. active(1) -i… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.3 |
| hwDot3ahEfmMaxOamPduSize The largest OAMPDU that the OAM entity supports. OAM
entities exchange maximum OAMPDU sizes and negotiate to use
the smaller of the two maximum OAMPDU sizes between the peers.
Th… | column | octets Unsigned32 | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.4 |
| hwDot3ahEfmConfigRevision The configuration revision of the OAM entity as reflected in
the latest OAMPDU sent by the OAM entity. The config revision
is used by OAM entities to indicate configuration chang… | column | Unsigned32 | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.5 |
| hwDot3ahEfmFunctionsSupported The OAM functions supported on this Ethernet like interface.
OAM consists of separate functional sets beyond the basic
discovery process which is always required. These functiona… | column | Bits | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.6 |
| hwDot3ahEfmTimeout The EFM Timeout object defines the max time that the EFM session
stays in detect mode since the last OAMPDU received. if there's
no OAMPDU received within the time the timeout va… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.7 |
| hwDot3ahEfmInterval The EFM interval object defines the interval of sending OAM PDUs.
The value of EFM interval should be the same as the value of
the peer interface.
T… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.2011.5.25.136.1.2.2.2.1.8 |