hm2IOModConfigDigOutputSourcePort

HM2-IOMODULE-MIB · .1.3.6.1.4.1.248.11.100.1.1.3.1.7
MIB view Table view

Object

column r/w INET-ADDRESS-MIBInetPortNumber 
The SNMP port number being used by the input mirrored to the output.
This port would be the destination of the SNMP requests for 
polling the state of the input.

Context

MIB
HM2-IOMODULE-MIB
OID
.1.3.6.1.4.1.248.11.100.1.1.3.1.7
Type
column
Access
readwrite
Status
current
Parent
hm2IOModConfigDigOutputEntry
Table
hm2IOModConfigDigOutputTable
Siblings
8

Syntax

INET-ADDRESS-MIBInetPortNumber
Source
INET-ADDRESS-MIBInetPortNumber
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..65535

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
hm2IOModConfigDigOutputModID
The module ID of an output. Module ID 0 corresponds to the power supply module.
columnInteger32.1.3.6.1.4.1.248.11.100.1.1.3.1.1
hm2IOModConfigDigOutputID
The ID of an output.
columnInteger32.1.3.6.1.4.1.248.11.100.1.1.3.1.2
hm2IOModConfigDigOutputLogEvent
Trigger an event log when output status changes. If the value is disable (2), no event log entry will be written. If the value is enable (1), an event log entry will be written wh…
columnHM2-TC-MIBHmEnabledStatus.1.3.6.1.4.1.248.11.100.1.1.3.1.3
hm2IOModConfigDigOutputSnmpTrap
Trigger an SNMP trap log when output status changes. If the value is disable (2), no SNMP trap will be sent. If the value is enable (1), a SNMP trap will be sent when the output s…
columnHM2-TC-MIBHmEnabledStatus.1.3.6.1.4.1.248.11.100.1.1.3.1.4
hm2IOModConfigDigOutputSourceAddressType
Address type of an input mirrored to the output. Currently, only ipv4 is supported.
columnINET-ADDRESS-MIBInetAddressType.1.3.6.1.4.1.248.11.100.1.1.3.1.5
hm2IOModConfigDigOutputSourceAddress
The IP address of an input mirrored to the output. Use 0.0.0.0 if the output should not be set. In this case hm2IOModValueDigOutputValue is not-configured(4). Use 127.0.0.1 if a l…
columnINET-ADDRESS-MIBInetAddress.1.3.6.1.4.1.248.11.100.1.1.3.1.6
hm2IOModConfigDigOutputSourceModID
The module ID of an input mirrored to the output. Module ID 0 corresponds to the power supply module. Ignored when hm2IOModConfigDigOutputSourceIP is 0.0.0.0.
columnInteger32.1.3.6.1.4.1.248.11.100.1.1.3.1.8
hm2IOModConfigDigOutputSourceID
The ID of an input mirrored to the output. Ignored when hm2IOModConfigDigOutputSourceIP is 0.0.0.0.
columnInteger32.1.3.6.1.4.1.248.11.100.1.1.3.1.9