extremeErpsRingProtectionType
EXTREME-ERPS-MIB ·
.1.3.6.1.4.1.1916.1.46.2.1.15
Object
column
Enumeration
This object specifies the type of protection being provided by this
ring instance. The following two protection switching types are
possible:
portBased - Port Based Protection
This ring applies the protection switching mechanism
for all traffic that pass through its ring ports.
Hence when ERP control process decides to block or
unblock a ring port, all data traffic that passes
through that port gets affected.
serviceBased - Service Based Protection.
This ring applies the protection switching mechanism
only for the set of vlans mapped to this ring instance.
Hence when ERP control process decides to block or
unblock a ring port, only the data traffic of the vlans
that are mapped to this ring instance and that passes
through that port gets affected.
All ring nodes in a single ring instance must be configured with the
same protection type.
In a single virtual context one ring can run in port based protection
mode and another ring can run in service based protection mode.
It is not recommended to configure a port as ring port in a port based
ring instance as well as in a service based ring instance.
It is not recommended to configure a port as ring port in multiple port
based ring instance.
The ring protection type can be modified only when the row status of
the ring entry in not in service.
Context
- MIB
- EXTREME-ERPS-MIB
- OID
.1.3.6.1.4.1.1916.1.46.2.1.15- Type
- column
- Access
- readonly
- Status
- current
- Parent
- extremeErpsRingEntry
- Table
- extremeErpsRingTable
- Siblings
- 17
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | portBased |
2 | serviceBased |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| extremeErpsRingName The ERPS domain name. | column | OctetString | .1.3.6.1.4.1.1916.1.46.2.1.1 |
| extremeErpsRingEastStatus This object indicates ring port1's current status updated by
ERPS control process of this ring.
If the status is blocked then:
- Data traffic will be blocked on this port.
… | column | Enumeration | .1.3.6.1.4.1.1916.1.46.2.1.10 |
| extremeErpsRingWestStatus This object indicates ring port2's current status updated by
ERPS control process of this ring.
If the status is blocked then:
- Data traffic will be blocked on this port.
… | column | Enumeration | .1.3.6.1.4.1.1916.1.46.2.1.11 |
| extremeErpsRingSemState This object gives the node state as per the G.8032 state event
machine. When ring Row status is not active or when ERPS is disabled
in the virtual context, this object will show … | column | Enumeration | .1.3.6.1.4.1.1916.1.46.2.1.12 |
| extremeErpsRingNodeStatus General attributes giving the current status of the ring by specifying the
events/status currently present.
signalFailOnEast(0) - Signal-failure on Ring … | column | Bits | .1.3.6.1.4.1.1916.1.46.2.1.13 |
| extremeErpsRingRplNeighbourPort This object identifies the RPL Neighbour port of the ring .
Valid values for this object are '0', 'IfIndex of extremeErpsRingEast' and
'IfIndex of extremeErpsRingW… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.1916.1.46.2.1.14 |
| extremeRingCfmGroup1 Connectivity Fault Management group 1 | column | OctetString | .1.3.6.1.4.1.1916.1.46.2.1.16 |
| extremeRingCfmGroup2 Connectivity Fault Management group 2 | column | OctetString | .1.3.6.1.4.1.1916.1.46.2.1.17 |
| extremeErpsRingCfmRowStatus The status of this entry as per standard RowStatus conventions. | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.1916.1.46.2.1.18 |
| extremeErpsRingVlanId This object identifies the dedicated VLAN Id used by a ring for its
R-APS messages communication.
It is recommended that the,
* R-APS VLANs should be used only… | column | Q-BRIDGE-MIBVlanId | .1.3.6.1.4.1.1916.1.46.2.1.2 |
| extremeErpsRingEast First port of the two ring ports participating in the ring. Any
interface with valid interface ID can be configured as a ring port. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.1916.1.46.2.1.3 |
| extremeErpsRingWest Second port of the two ring ports participating in the ring. Any
interface with valid interface ID can be configured as a ring port.
On the interconnected node of a sub-ring, thi… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.1916.1.46.2.1.4 |
| extremeErpsRingRplPort This object identifies the RPL port of the ring.
Valid values for this object are '0', 'IfIndex of extremeErpsRingEast' and
'IfIndex of extremeErpsRingWest'.
… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.1916.1.46.2.1.5 |
| extremeErpsRingPortBlockingOnVcRecovery This object is applicable for the interconnected nodes of a sub-ring.
This configuration helps to avoid the possibility of temporary loops
getting formed in the sub-ring during … | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.1916.1.46.2.1.6 |
| extremeErpsRingNodeType This object identifies the node state of this ring node.
If extremeErpsRingRplPort is configured for a ring node, then that ring
node becomes 'rplOwner', otherwise the node remai… | column | Enumeration | .1.3.6.1.4.1.1916.1.46.2.1.7 |
| extremeErpsRingOperatingMode This object identifies whether the ring is operating in revertive or
nonRevertive manner.
In revertive mode of operation, once the failed link recovers, the data
path will be swit… | column | Enumeration | .1.3.6.1.4.1.1916.1.46.2.1.8 |
| extremeErpsRingMonitorMechanism This object indicates the type of monitoring mechanism used for
detecting faults of the ring link.
Currently 'cfm' is supported as monitoring mechanism. For 'cfm'… | column | RingMonitorMechanismType | .1.3.6.1.4.1.1916.1.46.2.1.9 |