cwrChanOamRetryInterval
CISCO-WAN-RPM-CONN-EXT-MIB ·
.1.3.6.1.4.1.351.150.9.1.1.1.1.10
Object
column
r/w
seconds Unsigned32
The frequency that end-to-end F5 OAM loopback cells are transmitted when a change in UP/DOWN state of a PVC is being verified. This object only applies if OAM management is enabled (i.e. cwrChanOAMManage = true).
Context
- MIB
- CISCO-WAN-RPM-CONN-EXT-MIB
- OID
.1.3.6.1.4.1.351.150.9.1.1.1.1.10- Type
- column
- Access
- readwrite
- Status
- current
- Units
- seconds
- Parent
- cwRpmChanExtEntry
- Table
- cwRpmChanExtTable
- Siblings
- 9
Syntax
seconds Unsigned32
Values & Constraints
Object Constraints
range: 1-1000
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cwrChanSubInterface The RPM's backplane sub-interface for which this channel
is configured. Sub-interface 0 means the switch port. | column | Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.1 |
| cwrChanVcd Virtual Circuit Descriptor. A unique number which identifies
a connection. | column | Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.2 |
| cwrChanAalEncapType ATM adaptation layer (AAL) and Encapsulation type.
aal5ciscoPPP - For Cisco PPP over ATM.
'cwrChanVirtualTemplate' is required to be
… | column | Enumeration | .1.3.6.1.4.1.351.150.9.1.1.1.1.3 |
| cwrChanVirtualTemplate This object identifies the virtual template.
The non-zero value need to be specified for
Cisco PPP or MUX-type PPP encapsulation
(i.e. cwrChanAalEncapType = aal5c… | column | Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.4 |
| cwrChanInArpInterval This specifies how often Inverse ARP datagrams will be sent
on this channel. 0 will disable the InArp for this channel.
This object is only supported for aal5snap encapsulation
(… | column | minutes Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.5 |
| cwrChanOamLoopbkTxInterval This specifies how often to generate an OAM F5 loopback cell
from this channel. 0 will disable generation of OAM F5
loopback cells. | column | seconds Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.6 |
| cwrChanOamManage This enables/disables OAM management for this channel.
If set to true(1), OAM management is enabled. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.351.150.9.1.1.1.1.7 |
| cwrChanOamRetryUpCount Number of consecutive end-to-end F5 OAM loopback cell
responses that must be received in order to change a PVC
connection state to up.
This object only applies if OAM management i… | column | Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.8 |
| cwrChanOamRetryDownCount Number of consecutive end-to-end F5 OAM loopback cell
responses that are not received in order to change a PVC
connection state to down.
This object only applies if OAM management… | column | Unsigned32 | .1.3.6.1.4.1.351.150.9.1.1.1.1.9 |