cwrChanAalEncapType

CISCO-WAN-RPM-CONN-EXT-MIB · .1.3.6.1.4.1.351.150.9.1.1.1.1.3

Object

column r/w Enumeration

ATM adaptation layer (AAL) and Encapsulation type.
              
aal5ciscoPPP     - For Cisco PPP over ATM.
                   'cwrChanVirtualTemplate' is required to be
                   set for this type.
aal5muxAPOLLO    - For a multiplex (MUX) - type virtual
                   circuit using the Apollo protocol.
aal5muxAPPLETALK - For a MUX-type virtual circuit using the
                   AppleTalk protocol.
aal5muxDECNET    - For a MUX-type virtual circuit using the
                   DECnet protocol.
aal5muxIP        - For a MUX-type virtual circuit using the
                   IP protocol.
aal5muxIPX       - For a MUX-type virtual circuit using the
                   IPX protocol.
aal5muxPPP       - For a MUX-type virtual circuit using the
                   PPP protocol.
                   'cwrChanVirtualTemplate' is required to be
                   set for this type.
aal5muxVINES     - For a MUX-type virtual circuit using the
                   VINES protocol.
aal5muxXNS       - For a MUX-type virtual circuit using the
                   XNS protocol.
aal5nlpid        - Allows ATM interfaces to interoperate with
                   HSSI.
aal5snap         - The only encapsulation supported for
                   Inverse ARP. Logical Link Control/
                   Subnetwork Access Protocol (LLC/SNAP)
                   precedes the protocol datagram.
ilmi             - Used to set up communication with ILMI.
qsaal            - A signalling type PVC used for setting up
                   or tearing down SVCs.

Context

MIB: CISCO-WAN-RPM-CONN-EXT-MIB
OID: .1.3.6.1.4.1.351.150.9.1.1.1.1.3
Type: column
Access: readwrite
Status: current
Parent: cwRpmChanExtEntry
Table: cwRpmChanExtTable
Siblings: 9

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	aal5ciscoPPP
`2`	aal5muxAPOLLO
`3`	aal5muxAPPLETALK
`4`	aal5muxDECNET
`5`	aal5muxIP
`6`	aal5muxIPX
`7`	aal5muxPPP
`8`	aal5muxVINES
`9`	aal5muxXNS
`10`	aal5nlpid
`11`	aal5snap
`12`	ilmi
`13`	qsaal

Related Objects

Sibling Objects

Object	Type	Syntax	OID
cwrChanSubInterface The RPM's backplane sub-interface for which this channel is configured. Sub-interface 0 means the switch port.	column	Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.1`
cwrChanOamRetryInterval The frequency that end-to-end F5 OAM loopback cells are transmitted when a change in UP/DOWN state of a PVC is being verified. This object only applies if OAM management is enable…	column	seconds Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.10`
cwrChanVcd Virtual Circuit Descriptor. A unique number which identifies a connection.	column	Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.2`
cwrChanVirtualTemplate This object identifies the virtual template. The non-zero value need to be specified for Cisco PPP or MUX-type PPP encapsulation (i.e. cwrChanAalEncapType = aal5c…	column	Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.4`
cwrChanInArpInterval This specifies how often Inverse ARP datagrams will be sent on this channel. 0 will disable the InArp for this channel. This object is only supported for aal5snap encapsulation (…	column	minutes Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.5`
cwrChanOamLoopbkTxInterval This specifies how often to generate an OAM F5 loopback cell from this channel. 0 will disable generation of OAM F5 loopback cells.	column	seconds Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.6`
cwrChanOamManage This enables/disables OAM management for this channel. If set to true(1), OAM management is enabled.	column	SNMPv2-TCTruthValue	`.1.3.6.1.4.1.351.150.9.1.1.1.1.7`
cwrChanOamRetryUpCount Number of consecutive end-to-end F5 OAM loopback cell responses that must be received in order to change a PVC connection state to up. This object only applies if OAM management i…	column	Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.8`
cwrChanOamRetryDownCount Number of consecutive end-to-end F5 OAM loopback cell responses that are not received in order to change a PVC connection state to down. This object only applies if OAM management…	column	Unsigned32	`.1.3.6.1.4.1.351.150.9.1.1.1.1.9`