vmVmpsReconfirmResult

CISCO-VLAN-MEMBERSHIP-MIB · .1.3.6.1.4.1.9.9.68.1.1.5

Object

scalar Enumeration

This object returns the result of the last request
that sets vmVmpsReconfirm to execute(2). The
semantics of the possible results are as follows:
          
     other(1)           - none of following
     inProgress(2)      - reconfirm in progress
     success(3)         - reconfirm completed successfully
     noResponse(4)      - reconfirm failed because no
                          VMPS responded
     noVmps(5)          - No VMPS configured
     noDynamicPort(6)   - No dynamic ports configured
     noHostConnected(7) - No hosts on dynamic ports

Context

MIB: CISCO-VLAN-MEMBERSHIP-MIB
OID: .1.3.6.1.4.1.9.9.68.1.1.5
Type: scalar
Access: readonly
Status: current
Parent: vmVmps
Siblings: 6

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	other
`2`	inProgress
`3`	success
`4`	noResponse
`5`	noVmps
`6`	noDynamicPort
`7`	noHostConnected

Related Objects

Sibling Objects

Object	Type	Syntax	OID
vmVmpsVQPVersion The VLAN Query Protocol (VQP) version supported on the device. VQP is the protocol used to query VLAN Membership Policy Server (VMPS) for VLAN membership assignments of dynamic VL…	scalar	SNMPv2-SMIInteger32	`.1.3.6.1.4.1.9.9.68.1.1.1`
vmVmpsRetries The number of retries for VQP requests to a VMPS before using the next available VMPS.	scalar	Integer32	`.1.3.6.1.4.1.9.9.68.1.1.2`
vmVmpsReconfirmInterval The switch will reconfirm membership of addresses on each port with VMPS periodically. This object specifies the interval to perform reconfirmation. If the value is set to 0, the …	scalar	Minutes Integer32	`.1.3.6.1.4.1.9.9.68.1.1.3`
vmVmpsReconfirm Setting this object to execute(2) causes the switch to reconfirm membership of every dynamic port. Reading this object always return ready(1).	scalar	Enumeration	`.1.3.6.1.4.1.9.9.68.1.1.4`
vmVmpsCurrent This is the IpAddress of the current VMPS used.	scalar	SNMPv2-SMIIpAddress	`.1.3.6.1.4.1.9.9.68.1.1.6`
vmVmpsTable A table of VMPS to use. The device will use the the primary VMPS by default. If the device is unable to reach the primary server after vmVmpsRetries retries, it uses the first sec…	table	-	`.1.3.6.1.4.1.9.9.68.1.1.7`