ds0CasMinStartDialTime

This is an object for an E & M signaling protocol like 
wink-start for this ds0.  The difference is that the 
address-control signal is different from wink. The originating 
VISM, on receiving a seize (AB=11) from the PBX,
responds by sending the delay-dial (AB=11) signal back 
to the PBX.  When the originating VISM is ready to collect 
the digits, it sends a start-dial (AB=00) signal.  
This operation is symmetric.  So the terminating VISM, on
seizing a trunk, should receive AB=11 
(as an ack that the trunk is operational). Subsequently, 
when it receives the start signal (AB=00) from
the connected PBX, it should outpulse the digits.  
The rest of the operation is similiar to wink-start.
              
The allowed range for this object is 70..1000.
              
In delay-dial operation, the outgoing interface (this interface),
after receiving a delay-dial signal (AB=11) from the connected 
equipment, waits for the start-dial signal (AB = 00) before 
sending the digits to the connected equipment. 
The start-dial signal tells this interface that the
connected equipment is ready for the digits. 
This object specifies the time in milliseconds, after which 
incoming AB=00 will be interpreted by this interface as the 
start dial signal.

MIB

CISCO-VISM-DSX0-MIB

OID

.1.3.6.1.4.1.351.110.4.7.1.1.26

Type

column

Access

readwrite

Status

current

Units

milliseconds

Parent

dsx0VismCnfEntry

Groups

2