sysStartupConfigSourceFile

CISCO-STACK-MIB · .1.3.6.1.4.1.9.5.1.1.51
Commands MIB view Table view

Object

scalar r/w SNMPv2-TCDisplayString 
Indicates which configuration file(s) on the
flash device will be used during the next system
startup.
If the value of this MIB object contains one or
multiple valid configuration file(s), then the
valid configuration file(s) will reconfigure the
system during the next system startup one by one
in the order specified. If the value of this MIB
object does not contain the valid configuration
file(s) on the device, the NVRAM configuration
will be used instead.
          
For supervisor models wsx5540 and wsx5550, only
'cfg1' and 'cfg2' are valid file names.
          
For supervisor models with the flash file system
support, the valid file name has the format of
'<device:><file>[;<device:><file>...]'.
          
This MIB object is only supported in systems with
supervisor models wsx5540 and wsx5550 or
supervisor models with the flash file system
support.

Context

MIB
CISCO-STACK-MIB
OID
.1.3.6.1.4.1.9.5.1.1.51
Type
scalar
Access
readwrite
Status
current
Parent
systemGrp
Groups
1

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'CISCO-STACK-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-STACK-MIB::sysStartupConfigSourceFile.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'CISCO-STACK-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'CISCO-STACK-MIB::sysStartupConfigSourceFile'

Syntax

SNMPv2-TCDisplayString
Source
SNMPv2-TCDisplayString
Base type
OctetString
Display format
255a
Type Description
Represents textual information taken from the NVT ASCII
          
character set, as defined in pages 4, 10-11 of RFC 854.
          
To summarize RFC 854, the NVT ASCII repertoire specifies:
          
  - the use of character codes 0-127 (decimal)
          
  - the graphics characters (32-126) are interpreted as
    US ASCII
          
  - NUL, LF, CR, BEL, BS, HT, VT and FF have the special
    meanings specified in RFC 854
          
  - the other 25 codes have no standard interpretation
          
  - the sequence 'CR LF' means newline
          
  - the sequence 'CR NUL' means carriage-return
          
  - an 'LF' not preceded by a 'CR' means moving to the
    same column on the next line.
          
  - the sequence 'CR x' for any x other than LF or NUL is
    illegal.  (Note that this also means that a string may
    end with either 'CR LF' or 'CR NUL', but not with CR.)
          
Any object defined using this syntax may not exceed 255
characters in length.

Values & Constraints

Type Constraints
range: 0..255

Conformance

Member of
optionalSystemMiscGroup1