cMTInitiatorSourceInterface
CISCO-MEDIATRACE-MIB ·
.1.3.6.1.4.1.9.9.800.1.1.3
Object
This object specifies the interface whose IP or IPv6 address will be used as initiator address. The Initiator address is used by layer 2 mediatrace responder to unicast the response message to initiator. This address is also reachability address for mediatrace hop 0. The value of this object should be set to ifIndex value of the desired interface from the ifTable.
Context
- MIB
- CISCO-MEDIATRACE-MIB
- OID
.1.3.6.1.4.1.9.9.800.1.1.3- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- cMTCtrl
- Groups
- 1
Net-SNMP examples
How SNMP and these commands workScalars have one instance, identified by the .0 suffix.
Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'CISCO-MEDIATRACE-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-MEDIATRACE-MIB::cMTInitiatorSourceInterface.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'CISCO-MEDIATRACE-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'CISCO-MEDIATRACE-MIB::cMTInitiatorSourceInterface'
Syntax
- Source
- IF-MIBInterfaceIndexOrZero
- Base type
Integer32- Display format
d
Type Description
This textual convention is an extension of the InterfaceIndex convention. The latter defines a greater than zero value used to identify an interface or interface sub-layer in the managed system. This extension permits the additional value of zero. the value zero is object-specific and must therefore be defined as part of the description of any object which uses this syntax. Examples of the usage of zero might include situations where interface was unknown, or when none or all interfaces need to be referenced.
Values & Constraints
Type Constraints
range: 0..2147483647
Conformance
Member of