cLApGlobalRetransmitCount

CISCO-LWAPP-AP-MIB · .1.3.6.1.4.1.9.9.513.1.3.14
MIB view Table view

Object

scalar r/w retries SNMPv2-SMIUnsigned32 
This object specifies the retransmission count for the
Control Packet of all the Access Points, joined to this 
controller. This value specifies the number of packets 
retransmitted after which the Access Point falls back to 
another controller in case of failover.

Context

MIB
CISCO-LWAPP-AP-MIB
OID
.1.3.6.1.4.1.9.9.513.1.3.14
Type
scalar
Access
readwrite
Status
current
Units
retries
Parent
ciscoLwappApGlobal
Siblings
35

Syntax

retries SNMPv2-SMIUnsigned32
Source
SNMPv2-SMIUnsigned32
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..4294967295

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
cLApFastHbTimerTable
This table contains entries for AP fast heartbeat timers configured in the controller. At startup, all the entries in this table are set up by the central controller. A managemen…
table-.1.3.6.1.4.1.9.9.513.1.3.1
cLApGlobalFailoverPriority
This object specifies the global AP failover priority. If Enabled, Priorities will be considered of the APs which wishes to join the controller. Preference will be given to the …
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.10
cLApGlobalTcpMss
This object specifies the Global AP TCP MSS value. Permissible value are between 536 and 1363. This will also enable the global TCP MSS flag. Value of 0 will disable the global TC…
scalarInteger32.1.3.6.1.4.1.9.9.513.1.3.11
cLApGlobalDot11IfTable
This table is used to configure the global dot11 parameters per slot id, represented by cLApDot11IfSlotId, of the radio interface in all the APs joined with the controller.
table-.1.3.6.1.4.1.9.9.513.1.3.12
cLApGlobalEthernetIfTable
This table is used to configure the global parameters on Ethernet interfaces of all the APs joined with the controller.
table-.1.3.6.1.4.1.9.9.513.1.3.13
cLApGlobalRetransmitTimeout
This object specifies the retransmission timeout for the Control Packet of all the Access Points, joined to this controller. This value specifies the timeout for each retransmis…
scalarseconds SNMPv2-SMIUnsigned32.1.3.6.1.4.1.9.9.513.1.3.15
cLApOeapDisableLocalAccess
This object specifies whether the local access is supported for all the Office Extended Access Points, joined to this controller. If set to true, the local SSID and and LAN ports…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.16
cLApGlobalLEDState
This object specifies whether the LED state of all the access points should be enabled or disabled.
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.17
cLApRadioInterfaceShutdownEnabled
This object specifies to enable or disable AP radio Interface. When enabled, AP radio's will be shut down when Ethernet link goes down for a duration of time set for cLApEtherne…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.18
cLApEthernetInterfaceDowntime
This object specifies the ethernet interface down time after which the AP radio interface will be shut down.
scalarSeconds SNMPv2-SMIUnsigned32.1.3.6.1.4.1.9.9.513.1.3.19
cLAPMulticastGroupAddressType
This object specifies the AP multicast group address type.
scalarINET-ADDRESS-MIBInetAddressType.1.3.6.1.4.1.9.9.513.1.3.20
cLAPMulticastGroupAddress
This object specifies the AP multicast group address.
scalarINET-ADDRESS-MIBInetAddress.1.3.6.1.4.1.9.9.513.1.3.21
cLAPMulticastMode
This object specifies the switch's ethernet multicast support. unicast - Controller will convert multicast to unicast packet. multicast - Multicast mode is enabled.
scalarEnumeration.1.3.6.1.4.1.9.9.513.1.3.22
cLApPrimedDiscoveryTimeout
This object specifies the primed timeout for the AP discovery.
scalarseconds Integer32.1.3.6.1.4.1.9.9.513.1.3.23
cLApGlobalPreferMode
This object specifies the global capwap prefer-mode. ipv4 - capwap tunnel established with ipv4 address. ipv6 - capwap tunnel established with ipv6 address.
scalarEnumeration.1.3.6.1.4.1.9.9.513.1.3.24
cLApGlobalAPLagCapability
This object specifies whether the ap-lag capability state of all the access points should be enabled or disabled. A value of 'true' indicates ap-lag capapbility is enabled. A valu…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.25
cLApGlobalAPDtlsVersion
This object specifies the dtls version of ap
scalarEnumeration.1.3.6.1.4.1.9.9.513.1.3.26
cLApGlobalAPDtlsCipherSuite
This object specifies the dtls cipher suite of ap
scalarEnumeration.1.3.6.1.4.1.9.9.513.1.3.27
cLApGlobalMaxApsSupported
This object represents the maximum number of APs supported by this controller.
scalarSNMPv2-SMIInteger32.1.3.6.1.4.1.9.9.513.1.3.28
cLApPrimaryDiscoveryTimeout
This object specifies the timeout for the primary AP discovery.
scalarseconds Unsigned32.1.3.6.1.4.1.9.9.513.1.3.3
cLApAuthorizeApMacAuth
This flag specifies the status of mac auth
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.30
cLApAuthorizeApSerialNumAuth
This flag specifies the status of serial number auth
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.31
cLApAuthorizeApMethodList
This object specifies the method list used for the AP authorization when enabled. The default method list is default
scalarSNMP-FRAMEWORK-MIBSnmpAdminString.1.3.6.1.4.1.9.9.513.1.3.32
cLApGlobalAPAuditReport
This object is used to enable/disable AP audit reporting. It is disabled by default
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.513.1.3.33
cLApGlobalAPAuditReportInterval
This object specifies the audit report interval in minutes. The default interval is 1440 minutes
scalarMinutes Unsigned32.1.3.6.1.4.1.9.9.513.1.3.34
cLApGlobalAPConnectCount
This object represents the Count of AP's that are connected to the Controller.
scalarSNMPv2-SMIUnsigned32.1.3.6.1.4.1.9.9.513.1.3.35
cLApAuthorizeApMacMethodList
This object specifies the method list used for the AP MAC authorization when enabled.
scalarSNMP-FRAMEWORK-MIBSnmpAdminString.1.3.6.1.4.1.9.9.513.1.3.36
cLApAuthorizeApSerialNumMethodList
This object specifies the method list used for the AP serial number authorization when enabled.
scalarSNMP-FRAMEWORK-MIBSnmpAdminString.1.3.6.1.4.1.9.9.513.1.3.37
clApImageUpgradeConfignode-.1.3.6.1.4.1.9.9.513.1.3.38
cLApGlobalPrimaryControllerAddressType
This object specifies the type of the primary controller's address made available through cLApPrimaryControllerAddress.
scalarINET-ADDRESS-MIBInetAddressType.1.3.6.1.4.1.9.9.513.1.3.4
cLApGlobalPrimaryControllerAddress
This object specifies the address of the primary controller that the APs will join. The name and address should be provided in the same set request. An address of all zeros will…
scalarINET-ADDRESS-MIBInetAddress.1.3.6.1.4.1.9.9.513.1.3.5
cLApGlobalPrimaryControllerName
This object specifies the name of the primary controller that the APs will join.
scalarOctetString.1.3.6.1.4.1.9.9.513.1.3.6
cLApGlobalSecondaryControllerAddressType
This object specifies the type of the secondary controller's address made available through cLApSecondaryControllerAddress.
scalarINET-ADDRESS-MIBInetAddressType.1.3.6.1.4.1.9.9.513.1.3.7
cLApGlobalSecondaryControllerAddress
This object specifies the address of the secondary controller that the APs will join. The name and address should be provided in the same set request. An address of all zeros wi…
scalarINET-ADDRESS-MIBInetAddress.1.3.6.1.4.1.9.9.513.1.3.8
cLApGlobalSecondaryControllerName
This object specifies the name of the secondary controller that the APs will join.
scalarOctetString.1.3.6.1.4.1.9.9.513.1.3.9