cdtIfIpv4Unnumbered

CISCO-DYNAMIC-TEMPLATE-MIB · .1.3.6.1.4.1.9.9.784.1.2.1.1.5
Commands MIB view Table view

Object

column r/w IF-MIBInterfaceIndexOrZero 
This object specifies the interface of the source address that
the target interface uses when originating IPv4 packets.
              
The value '0' cannot be written to an instance of this object.
However, it serves as a convenient value when the column is
not valid (e.g., immediately following the creation of an
instance of the object).
              
This column is valid only if the 'ipv4Unnumbered' bit of the
corresponding instance of cdtIfValid is '1'.

Context

MIB
CISCO-DYNAMIC-TEMPLATE-MIB
OID
.1.3.6.1.4.1.9.9.784.1.2.1.1.5
Type
column
Access
readwrite
Status
current
Parent
cdtIfTemplateEntry
Groups
1

Net-SNMP examples

How SNMP and these commands work

Walk the column to discover its indexed instances, or supply every index to read one instance.

Walk the column
/usr/bin/snmpbulkwalk -v2c -c '<community>' -Pud -Ir -OQUs -m 'CISCO-DYNAMIC-TEMPLATE-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-DYNAMIC-TEMPLATE-MIB::cdtIfIpv4Unnumbered'
More examples
Read one indexed instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'CISCO-DYNAMIC-TEMPLATE-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-DYNAMIC-TEMPLATE-MIB::cdtIfIpv4Unnumbered.<cdtTemplateName>'
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'CISCO-DYNAMIC-TEMPLATE-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'CISCO-DYNAMIC-TEMPLATE-MIB::cdtIfIpv4Unnumbered'

Syntax

IF-MIBInterfaceIndexOrZero
Source
IF-MIBInterfaceIndexOrZero
Base type
Integer32
Display format
d
Type Description
This textual convention is an extension of the
InterfaceIndex convention.  The latter defines a greater
than zero value used to identify an interface or interface
sub-layer in the managed system.  This extension permits the
additional value of zero.  the value zero is object-specific
and must therefore be defined as part of the description of
any object which uses this syntax.  Examples of the usage of
zero might include situations where interface was unknown,
or when none or all interfaces need to be referenced.

Values & Constraints

Type Constraints
range: 0..2147483647

Conformance

Member of
cdtIfGroup