cDot11RadioDiagMode
CISCO-DOT11-RADIO-DIAGNOSTIC-MIB ·
.1.3.6.1.4.1.9.10.105.1.1.1.1.3
Object
column
r/w
Enumeration
Test mode as carried by the Cisco Radio Management
Extensions in the 802.11 beacon frame.
The semantics are described as follows.
normal - Indicates that the station is operating in
non-test mode.
apRadioDiscovery - Indicates that this station is
operating in AP Discovery mode. In this mode, APs
transmit and measure each other's beacons. APs
measure signal strength as received from other APs,
levels of RF interference experienced during
transmission / reception and report back the same to
the NM.
siteSurveyTempSettings - Indicates that
the station is operating in AP assisted site survey
mode with temporary channel and transmit power
settings applied to the dot11 interface identified
by ifIndex.
siteSurveyNonTempSettings - Indicates
that station is operating in AP assisted site survey
mode with it's original channel and transmit power
with the temporary settings not applied to the dot11
interface identified by ifIndex.
Context
- MIB
- CISCO-DOT11-RADIO-DIAGNOSTIC-MIB
- OID
.1.3.6.1.4.1.9.10.105.1.1.1.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cDot11RadioDiagEntry
- Table
- cDot11RadioDiagTable
- Siblings
- 5
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | normal |
2 | apRadioDiscovery |
3 | siteSurveyTempSettings |
4 | siteSurveyNonTempSettings |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cDot11RadioDiagTempChannel Temporary channel number for the 802.11 interface
identified by ifIndex.
The value this object takes depends on the value of
the object dot11PHYType defined in
IEEE… | column | Unsigned32 | .1.3.6.1.4.1.9.10.105.1.1.1.1.1 |
| cDot11RadioDiagTempTxPowerLevel Temporary transmit power level for the 802.11
interface identified by ifIndex.
A value in the range of 1 to 8 refers to one of the
power levels from the MIB table '… | column | Unsigned32 | .1.3.6.1.4.1.9.10.105.1.1.1.1.2 |
| cDot11RadioDiagSettingsEnabled A flag to indicate whether the station will apply
the temporary channel, transmit power settings and
the data rate sets configured in this entry to the
particular dot11 interface … | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.10.105.1.1.1.1.4 |
| cDot11RadioDiagTempClientTxPower Temporary transmit power level for the 802.11
clients associated with this station through the
802.11 interface identified by ifIndex.
The value configured through … | column | Unsigned32 | .1.3.6.1.4.1.9.10.105.1.1.1.1.5 |
| cDot11RadioDiagTempDataRateSet This object specifies the set of data rates at which
the station may transmit data through the dot11
interface identified by ifIndex. The semantics of
this object are similar to … | column | OctetString | .1.3.6.1.4.1.9.10.105.1.1.1.1.6 |