cDot11ClientPowerSaveMode
CISCO-DOT11-ASSOCIATION-MIB ·
.1.3.6.1.4.1.9.9.273.1.2.1.1.9
Object
column
Enumeration
The power management mode of this client. The
two possible modes are:
active(1) - this client is not in power-save
mode and it is actively sending or
receiving data.
powersave(2) - this client is in power-save mode and
it wakes up once a while to check for
pending data.
Context
- MIB
- CISCO-DOT11-ASSOCIATION-MIB
- OID
.1.3.6.1.4.1.9.9.273.1.2.1.1.9- Type
- column
- Access
- readonly
- Status
- current
- Parent
- cDot11ClientConfigInfoEntry
- Table
- cDot11ClientConfigInfoTable
- Siblings
- 25
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | active |
2 | powersave |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cDot11ClientAddress The MAC address of the client. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.9.273.1.2.1.1.1 |
| cDot11ClientAid This is the association identification number of
clients or multicast addresses associating with this
device. For a multicast address with clients, the
cDot11ClientAid is '0'. … | column | Unsigned32 | .1.3.6.1.4.1.9.9.273.1.2.1.1.10 |
| cDot11ClientDataRateSet This is the set of data rates at which this client
can transmit and receive data. Each client can
support up to 126 rates. Each octet contains an
integer value representing on… | column | OctetString | .1.3.6.1.4.1.9.9.273.1.2.1.1.11 |
| cDot11ClientSoftwareVersion This is the Cisco IOS software version if the other
end of the association is a bridge, access point, or
repeater. If it is a wireless client, this is the
firmware version of th… | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.9.9.273.1.2.1.1.12 |
| cDot11ClientName This is the Cisco IOS device hostname if the other
end of the association is a bridge, access point, or
repeater. If it is a wireless client, this is the
configured client name. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.9.9.273.1.2.1.1.13 |
| cDot11ClientAssociationState This object indicates the state of the authentication
and association process between the two parties:
initial(1) - association request
… | column | Enumeration | .1.3.6.1.4.1.9.9.273.1.2.1.1.14 |
| cDot11ClientIpAddressType This is the IP address type of the
cDot11ClientIpAddress. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.9.9.273.1.2.1.1.15 |
| cDot11ClientIpAddress This is the static or DHCP assigned IP address of the
client. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.9.9.273.1.2.1.1.16 |
| cDot11ClientVlanId This is the VLAN which this wireless client is
assigned to when it is successfully associated to the
wireless station. The value is 0 if this wireless
client is not assigned to … | column | CISCO-DOT11-IF-MIBCDot11IfVlanIdOrZero | .1.3.6.1.4.1.9.9.273.1.2.1.1.17 |
| cDot11ClientSubIfIndex This is the ifIndex of the sub-interface which this
wireless client is assigned to when it is successfully
associated to the wireless station. The value of this
object is 0, if t… | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.9.9.273.1.2.1.1.18 |
| cDot11ClientAuthenAlgorithm This is the IEEE 802.11 authentication methods
performed between the wireless station and this client
during association. | column | CDot11AuthenticationMethod | .1.3.6.1.4.1.9.9.273.1.2.1.1.19 |
| cDot11ClientParentAddress The MAC address of the parent of the client if the
client is a repeater AP. If this client has no parent,
the value is '00000000'h. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.9.273.1.2.1.1.2 |
| cDot11ClientAdditionalAuthen These are the additional authentications that were
performed after IEEE 802.11 Open System or Shared
Key authentication had completed. If none of the bits
is set, no additional M… | column | CDot11AdditionalAuthenMethod | .1.3.6.1.4.1.9.9.273.1.2.1.1.20 |
| cDot11ClientDot1xAuthenAlgorithm This the IEEE 802.1x authentication methods performed
between this wireless client and the authentication
server. If none of the bits is set, no IEEE 802.1x
authentication was … | column | CDot11Dot1xAuthenMethod | .1.3.6.1.4.1.9.9.273.1.2.1.1.21 |
| cDot11ClientKeyManagement deprecated This is the encryption key management methods
employed by this client for IEEE 802.11 wireless frame
encryption. If none of the bits is set, no key
management method is employed. | column | CDot11KeyManagementMethod | .1.3.6.1.4.1.9.9.273.1.2.1.1.22 |
| cDot11ClientUnicastCipher These are all the possible unicast data frame cipher
encryption type combinations currently supported on
this IEEE 802.11 client. If none of the bits is set,
the client is not p… | column | CISCO-DOT11-IF-MIBCDot11IfCipherType | .1.3.6.1.4.1.9.9.273.1.2.1.1.23 |
| cDot11ClientMulticastCipher These are all the possible multi-cast data frame
cipher encryption type combinations currently supported
on this IEEE 802.11 client. If none of the bits is set,
the client is not… | column | CISCO-DOT11-IF-MIBCDot11IfCipherType | .1.3.6.1.4.1.9.9.273.1.2.1.1.24 |
| cDot11ClientDevObjectID This object indicates the authoritative
identification of the associated 802.11 client as
assigned by the respective vendor. A value of '0.0'
shall be populated if no such identi… | column | ObjectIdentifier | .1.3.6.1.4.1.9.9.273.1.2.1.1.25 |
| cDot11ClientNewKeyManagement This is the encryption key management methods
employed by this client for IEEE 802.11 wireless frame
encryption. If none of the bits is set, no key
management method is employed. | column | CDot11NewKeyManagementMethod | .1.3.6.1.4.1.9.9.273.1.2.1.1.26 |
| cDot11ClientRoleClassType The role classification of the client. | column | CDot11ClientRoleClassType | .1.3.6.1.4.1.9.9.273.1.2.1.1.3 |
| cDot11ClientDevType The device type of the client. | column | CDot11ClientDevType | .1.3.6.1.4.1.9.9.273.1.2.1.1.4 |
| cDot11ClientRadioType The radio classification of the client. | column | CDot11ClientRadioType | .1.3.6.1.4.1.9.9.273.1.2.1.1.5 |
| cDot11ClientWepEnabled When this object is 'true', it indicates that the
WEP key mechanism is used for transmitting frames
of data for this client. The default value of this
object is 'false'. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.273.1.2.1.1.6 |
| cDot11ClientWepKeyMixEnabled When this object is 'true', it indicates that this
client is using WEP key mixing. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.273.1.2.1.1.7 |
| cDot11ClientMicEnabled When this object is 'true', it indicates that the
MIC is enabled for this client. The default value of
this object is 'false'. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.273.1.2.1.1.8 |