noWirelessChannelAvailableTrap
CAMBIUM-PTP500-MIB ·
.1.3.6.1.4.1.17713.5.99.0.15
Object
notification
Spectrum Management was unable to locate a suitable wireless channel to operate on
Context
- MIB
- CAMBIUM-PTP500-MIB
- OID
.1.3.6.1.4.1.17713.5.99.0.15- Type
- notification
- Status
- current
- Parent
- ptpTrapPrefix
- Siblings
- 22
Syntax
No syntax metadata recorded.
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| channelChangeTrap The PTP radio has changed wireless channel.
This has been caused by either
i) mandatory radar avoidance,
a DFS impulsive interference event will also be
detected,
or
ii) Dyn… | notification | - | .1.3.6.1.4.1.17713.5.99.0.1 |
| installArmStateTrap Indicates if the unit is being installed. NB: a value
other than 'disarmed' on startup, or a change of state
during operation may generate an SNMP trap and/or SMTP
email alert | notification | - | .1.3.6.1.4.1.17713.5.99.0.10 |
| unitOutOfCalibrationTrap The unit is out of calibration | notification | - | .1.3.6.1.4.1.17713.5.99.0.11 |
| incompatibleRegionCodesTrap The master and slave units have incompatible region
codes. NB: Both units must have compatible licence keys | notification | - | .1.3.6.1.4.1.17713.5.99.0.14 |
| wirelessLinkDisabledWarningTrap The SNMP ifAdminStatus of the wireless interface has
disabled wireless traffic | notification | - | .1.3.6.1.4.1.17713.5.99.0.16 |
| dataPortDisabledWarningTrap The SNMP ifAdminStatus of the Ethernet interface has
disabled Ethernet traffic | notification | - | .1.3.6.1.4.1.17713.5.99.0.17 |
| dataPortConfigurationMismatchTrap The detection of Ethernet fragments (runt packets) when
the link is in full duplex is an indication of an
auto-negotiation or forced configuration mismatch | notification | - | .1.3.6.1.4.1.17713.5.99.0.19 |
| dfsImpulsiveInterferenceTrap DFS impulsive interference detected event | notification | - | .1.3.6.1.4.1.17713.5.99.0.2 |
| incompatibleMasterAndSlaveTrap A non-zero value indicates that the master and slave
ends of a link are different hardware products, or have
different software versions. NB: It is very unusual to
detect this,… | notification | - | .1.3.6.1.4.1.17713.5.99.0.20 |
| sNTPSyncTrap If SNTP Sync fails then check the server settings in the
Remote Management page, or disable SNTP. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.5.99.0.21 |
| tDDSynchronizationAlarmTrap Not Synchronized indicates failure of the external
timing system for a period greater than the holdover
timer. TDD frame timing will have drifted, and this link
may cause inter… | notification | - | .1.3.6.1.4.1.17713.5.99.0.22 |
| linkModeOptimizationMismatchTrap The remote node of this link has been configured with a
different link mode optimization | notification | - | .1.3.6.1.4.1.17713.5.99.0.25 |
| capacityLicenseMismatchTrap The local and remote units have different licensed
capacity and/or the full capacity trial has been
activated at only one unit. The wireless link is
operating at the capacity o… | notification | - | .1.3.6.1.4.1.17713.5.99.0.27 |
| dataPortStatusTrap Current status of the Ethernet link. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.5.99.0.3 |
| syslogStateTrap The syslog service has been enabled or disabled | notification | - | .1.3.6.1.4.1.17713.5.99.0.30 |
| syslogLocalNearlyFullTrap The syslog local log is nearly full (90%) | notification | - | .1.3.6.1.4.1.17713.5.99.0.31 |
| syslogLocalWrappedTrap The syslog local log has wrapped | notification | - | .1.3.6.1.4.1.17713.5.99.0.32 |
| syslogClientTrap Enable or disable the syslog client | notification | - | .1.3.6.1.4.1.17713.5.99.0.33 |
| telecomsChannelStatusTrap Current status of telecoms channel. NB: a change of
state may generate an SNMP trap and/or SMTP email alert | notification | - | .1.3.6.1.4.1.17713.5.99.0.4 |
| telecomsLoopbackTrap The loopback status of telecoms channel. This is
intended for installation testing and should be set to
'None' for normal operation. The wire connections to a
unit can be teste… | notification | - | .1.3.6.1.4.1.17713.5.99.0.6 |
| regionCodeTrap The region code prohibits the wireless unit from
operating outside the regulated limits. An invalid region
code indicates a corrupted licence key. NB: a change of
state may gen… | notification | - | .1.3.6.1.4.1.17713.5.99.0.8 |
| installStatusTrap A non-zero value indicates that signalling was received
with the wrong MAC address or a mismatched link name. NB:
It is very unusual to detect this, because units with
mis-conf… | notification | - | .1.3.6.1.4.1.17713.5.99.0.9 |