aniBsuWirelessPtPConfChannelWidth

The Channel Width.
width-2 refers to 2MHz, width-3 refers to 3MHz
width-4 refers to 4MHz, width-5 refers to 5MHz,width-6 refers to 6MHz
width-7 refers to 7MHz, width-1-75 refers to 1.75MHz, width-3-5 refers to 3.5MHz
	Channel Width depends on Frequency Band. The valid range  is as follows:
	3.5 GHz (ETSI)  should allow channel width 3.5, 7; the rest of bands
	should allow channel width 2,3, 4, 5 and 6
	The Channel Width, Frame size, Downstream/Upstream ratio and cell radius are dependent on each other and the following
restrictions should be taken into account when configuring the system:
	Low Latency Mode
Channel Width = 1.75, 2, 3, 3.5 or 4 Not supported
Channel Width = 5, distance must be <= 30km 
	Percentage downstream bandwidth must be >= 50 
	Channel Width = 6 or 7, distance must be <= 40km
	Percentage downstream bandwidth must be >= 50 
          
	Normal Mode
	Channel Width = 1.75 Not supported
	Channel Width = 2, if DS/US is 50/50 then distance must be <100km
	Channel Width = 2, if DS/US is 60/40 then distance must be <90km
	Channel Width = 2, if DS/US is 70/30 then distance must be <50km
          
	Channel Width = 3, if DS/US is 50/50 then distance must be <100km
	Channel Width = 3, if DS/US is 60/40 then distance must be <100km
	Channel Width = 3, if DS/US is 70/30 then distance must be <90km
          
Channel Width = 3.5, 4,5, 6 and 7, DS/US must be >= 50 
          
	Note: It is required to upload the configuration and then reboot the device for the changes to take effect.

MIB

BSUWIRELESSIF-MIB

OID

.1.3.6.1.4.1.4325.3.2.10.2

Type

scalar

Access

readwrite

Status

current

Parent

aniBsuWirelessPtPConfGroup

Siblings

13