cmUsCalDiplexerType

BRCM-CM-ENGINEERING-MIB · .1.3.6.1.4.1.4413.2.99.1.1.3.2.3.15
Commands MIB view Table view

Object

scalar r/w Enumeration 
Controls and reflects the diplexer type on this board.  The primary
effect that this setting has is to control the range of frequencies
used in upstream calibration when operating in annex B mode.  A board
with a lowSplit diplexer will be calibrated over a frequency range of
5..42 MHz, while a board with a midSplit diplexer will be calibrated
over a frequency range of 5..85 MHz.  This setting does not affect the
calibration of an annex A board, which will always have a frequency
range of 5..65 MHz.

Context

MIB
BRCM-CM-ENGINEERING-MIB
OID
.1.3.6.1.4.1.4413.2.99.1.1.3.2.3.15
Type
scalar
Access
readwrite
Status
current
Parent
cmEngrUpstreamCalibration

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'BRCM-CM-ENGINEERING-MIB' -M '/opt/observium/mibs/broadcom:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'BRCM-CM-ENGINEERING-MIB::cmUsCalDiplexerType.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'BRCM-CM-ENGINEERING-MIB' -M '/opt/observium/mibs/broadcom:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'BRCM-CM-ENGINEERING-MIB::cmUsCalDiplexerType'

Syntax

Enumeration

Values & Constraints

No enumerated values or constraints recorded.