mobileStatCSQ
BINTEC-MOBILE-MIB ·
.0.4.1.22.1.12
Object
The GSM receive signal level in decibel (db). A value below -100 signals a very low signal quality. A value between -100 and -80 means that signal quality is low. If the value is between -80 and -70 the quality is ok. The interval from -70 to -60 signals a good quality and if the value is above -60 the quality is excellent. The default e.g. initial value is -113.
Context
- MIB
- BINTEC-MOBILE-MIB
- OID
.0.4.1.22.1.12- Type
- column
- Access
- readonly
- Status
- current
- Units
- dBm
- Parent
- mobileStatEntry
- Table
- mobileStatTable
- Siblings
- 23
Syntax
dBm SNMPv2-SMIInteger32
- Source
- SNMPv2-SMIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| mobileStatIfIndex The interface index of the corresponding TTY interface. | column | SNMPv2-SMIInteger32 | .0.4.1.22.1.1 |
| mobileStatCellId The actual Cell-ID the UMTS-Modem is registered. | column | OctetString | .0.4.1.22.1.10 |
| mobileStatAccessType The Access Type the modem actually registers on.
Normally the `edge' or `hs*pa' Access Types aren't
provided in detail by the network operator and/or modem.
Possible Access Types … | column | Enumeration | .0.4.1.22.1.11 |
| mobileStatIMEI The IMEI (International Mobile Equipment Identity)
of the detected mobile device. | column | OctetString | .0.4.1.22.1.13 |
| mobileStatCtrlIfIndex If the UMTS card provides several channels and one could
be used to control the card e.g. get status information
from the card like the signal quality a dedicated daemon
uses the … | column | SNMPv2-SMIInteger32 | .0.4.1.22.1.14 |
| mobileStatGpsSupport Signals for configuration software if the hardware
is capable to deliver GPS information.
- none(1) no GPS support
- available(2) GPS support available | column | Enumeration | .0.4.1.22.1.15 |
| mobileStatIccId The ICC-ID of the SIM-Card found in the mobile device
which is actually enumerated with mobileStatIfIndex.
Some UMTS modem vendors offer no capability to
read this … | column | OctetString | .0.4.1.22.1.16 |
| mobileStatHomePLMN The PLMN (Public Land Mobile Network) code of the Home PLMN. | column | SNMPv2-SMIInteger32 | .0.4.1.22.1.17 |
| mobileStatSubscriberNumber The Subscriber Number stored on the SIM card. | column | OctetString | .0.4.1.22.1.18 |
| mobileStatServiceCenterAddr The Service Center Address stored on the SIM card. | column | OctetString | .0.4.1.22.1.19 |
| mobileStatOperStatus The operational status of the GSM modem. The following
states can occur:
- up(1) the device is up - initialization finished
- down(2) the device is down
- init… | column | Enumeration | .0.4.1.22.1.2 |
| mobileStatLteSupport Signals for configuration software if the hardware
is capable to attach to LTE networks.
- none(1) no LTE support
- available(2) LTE support available | column | Enumeration | .0.4.1.22.1.20 |
| mobileStatBand The Band Class currently used. | column | Enumeration | .0.4.1.22.1.21 |
| mobileStatSmsStorageBits The SMS storage types supported by the modem hardware. | column | Bits | .0.4.1.22.1.22 |
| mobileStatAction Perform extern triggered Action on sierra wireless modems
- idle no waiting Action
- reset reset the modem
- qmi switch modem into qmi mode
- dip … | column | Enumeration | .0.4.1.22.1.23 |
| mobileStatATexec Perform a User requested AT Command in idle state | column | OctetString | .0.4.1.22.1.24 |
| mobileStatErrorCode If an error occurs (OperStatus is set to error) this variable
shows the reason for the error. Currently the following error
codes are possible:
- none(1) no error occured
-… | column | Enumeration | .0.4.1.22.1.3 |
| mobileStatCommand The last command that was sent to the mobile device. | column | OctetString | .0.4.1.22.1.4 |
| mobileStatAnswer The last answer received from the mobile device. | column | OctetString | .0.4.1.22.1.5 |
| mobileStatInDiscards The number of frames which can't be enqueued upstream. | column | SNMPv2-SMIInteger32 | .0.4.1.22.1.6 |
| mobileStatSelectedPLMN The PLMN (Public Land Mobile Network) code of the Network
currently selected. | column | SNMPv2-SMIInteger32 | .0.4.1.22.1.7 |
| mobileStatNetwork The name of the PLMN (Public Land Mobile Network)
actually being used. | column | OctetString | .0.4.1.22.1.8 |
| mobileStatLocationAreaCode The actual Location Area Code the UMTS-Modem is registered. | column | OctetString | .0.4.1.22.1.9 |