asamSysStatusBitMap

Status bitmap:
Bit 0: bit 0 is set if and only if none of the other bits is set.
Bit 1: bit 1 set indicates that persistent data has been lost
       including data necessary to establish OAM connectivity.
Bit 2: bit 2 set indicates that persistent data has been lost but
       not including data necessary to establish OAM connectivity.
Bit 3: bit 3 set indicates that a power-on reset has occured.  Notice
       that this also means that all reset-safe data has been lost.
Bit 4: bit 4 set indicates that a reset other than a power-on reset
       has occured.
Bit 5: not used anymore.
Bit 6: this bit indicates that alarm 'SHub configuration loss' (EQUIP
       alarm nbr 28) was raised. The purpose of using this bit is to
       clear this alarm by using asamSysStatusClearBitMap.
Bit 7: this bit indicates that one or several 'xVPS configuration
       loss' alarms (PlugInUnit2 alarm nbr 11) were raised.
       The purpose of using this bit is to clear the alarms by using
       asamSysStatusClearBitMap.
Bit 8: this bit indicates that alarm 'Invalid xVPS Pair Redundancy Data'
       (LSM Redundancy 131 nbr 2) was raised. The purpose of using this
       bit is to clear this alarm by using asamSysStatusClearBitMap.
          
Bit 9 .. 31 : reserved for future extensions.
          
ALCATEL NOTE:
   SUPPORT: YES   INSRVMOD: NA   RANGE: 1..4294967295
   PERSIST: YES   DEFVALUE: NA   UNITS: -

MIB

ASAM-SYSTEM-MIB

OID

.1.3.6.1.4.1.637.61.1.9.4

Type

scalar

Access

readonly

Status

current

Parent

asamSystemMIB