arrisMtaDevLoopVoltagePolicy

1. Maintain loop idle voltage at all times.
2. Apply loop idle voltage at all times except when no RF QAM carrier is
   detected.   The intent of this policy option is to maintain idle
   voltage for all normal operation but to remove it if RF conditions
   appear to match a malicious cable cut (such may happen if a burglar is
   trying to disable the alarm system).
3. Apply loop idle voltage only when the MTA device  is In-service (MTA IP
   address is received and valid config file has been received) and during
   manually initiated resets (either reset button or SNMP).  If this policy
   criterion is selected, then the EMTA MUST maintain loop idle voltage if a
   reset command is received (via SNMP or reset button or as part of a
   management initiated software upgrade).  Once the MTA has come back in-
   service,  any subsequent MTA out-of-service condition MUST result in
   removal of loop idle voltage (except for another manually initiated reset).
   As a failsafe, if the MTA has not come in-service within a provisionable
   time, then loop idle voltage MUST be removed.
4. Apply loop idle voltage whenever the MTA device is in-service.
5. This MIB is only writable via configuration file.

MIB

ARRIS-MTA-DEVICE-MIB

OID

.1.3.6.1.4.1.4115.1.3.3.1.2.3.11.2

Type

scalar

Access

readwrite

Status

current

Parent

arrisMtaDevLoopVoltageMgmt