adGenMuxPTimingSystemTimingType

This variable indicates the type of the system timing generated by the module.
If set to loopA/loopB, the module will provide packet based timing references
to the system. The module can only be configured to provide either loopA or
loopB timing reference and not both.
              
Some access modules can provide card level packet based timing reference to
the system. These reference sources are referred as Loop A and Loop B packet
references. Only two such sources, Loop A and Loop B, should exist within the
system at any given time.
              
The source(s) for the card level timing is provisioned on each access module
that desires to provide timing. Separate OIDs are used for this provisioning.
              
The phase difference between the system backplane timing and the card timing
reference is then computed by the detector hardware. The access module reads
the phase difference value from the detector and formats a timing packet for
transmission to the system.

MIB

ADTRAN-GENMUXPONDER-MIB

OID

.1.3.6.1.4.1.664.5.70.26.5.1.1.1.12

Type

column

Access

readwrite

Status

current

Default

none

Parent

adGenMuxPTimingProvEntry