adGenFrGroupEntry

The Frame Relay Group provisioning and status table entry.  To
create a frame relay group, the following procedures are used:
            
(1) The management application creates Frame Relay Group
    entry in the adGenFrGroupTable by setting the
    adGenFrGroupRowStatus to createAndWait(5).
            
    This may fail for the following reasons which are reported
    through the adGenFrSlotGroupLastCreateError object:
            
    - The selected ifIndex specifies an invalid interface
    - The selected ifIndex is already in use by another Frame
      Relay Group
            
    Otherwise, upon successful creation of the row, the group
    is reserved and a corresponding row (identical ifIndex)
    in the frMgtVcSigTable is created.
            
(2) The manager sets other provisioning rows in the
    adGenFrGroupTable and the frMgtVCSigTable that are
    appropriate for the service that is to be provided.
            
(3) Connect a frame relay link to the group to specify which
    interface is to provide service to the group.  See the
    adGenFrLinkTable description for more information.
            
(4) If no detectable errors or conflicts in the group
    provisioning is detected, the adGenFrSlotGroupLastCreateError
    object will contain an empty (zero length) string and
    and can be enabled by setting adGenFrGroupRowStatus to active(1).
                
(*) Signaling errors (if enabled) and any provisioning failures
    after setting the adGenFrGroupRowStatus to active(1) can be
    detected by examining the ifTable's ifOperStatus object.  If
    this value is not up(1), the adGenFrSlotGroupLastCreateError
    object will contain further diagnostic information as to the
    cause of any failure.

MIB

ADTRAN-GEN-FRAME-RELAY-MIB

OID

.1.3.6.1.4.1.664.5.70.29.1.1.2.1

Type

row

Status

current

Parent

adGenFrGroupTable

Table

adGenFrGroupTable

Children

16