h3cPseAutoDetectActive
A3COM-HUAWEI-POWER-ETH-EXT-MIB ·
.1.3.6.1.4.1.43.45.1.10.2.14.3
Object
scalar
r/w
Enumeration
The object specifies whether the device auto-detection feature is active. If this object is set to Active, and a known powered device is detected, then the port will automatically switch to Auto-Guaranteed mode. This is a stackwide object (ie. it is not referenced by group index).
Context
- MIB
- A3COM-HUAWEI-POWER-ETH-EXT-MIB
- OID
.1.3.6.1.4.1.43.45.1.10.2.14.3- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- h3cPowerEthernetExt
- Siblings
- 9
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | notSupported |
2 | disabled |
3 | enabled |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| h3cPsePortTable The indexing scheme is taken form that used by
the IETF Power MIB. The same indexing scheme is
used to give continuity in behaviour between
that standard and this extensions defi… | table | - | .1.3.6.1.4.1.43.45.1.10.2.14.1 |
| h3cPDPolicyMode The PD policy only applies to the situation that when a new
PD is inserted, and the power of PSE is overload.
A value of priority(2) means that the power will stop supplying
to th… | scalar | Enumeration | .1.3.6.1.4.1.43.45.1.10.2.14.10 |
| h3cMainPseTable Description. | table | - | .1.3.6.1.4.1.43.45.1.10.2.14.2 |
| h3cPseComformance | node | - | .1.3.6.1.4.1.43.45.1.10.2.14.4 |
| h3cPsePowerMaxValue The object specifies the max poe power for lanswitch.
The value should between the power currently and the max power. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.43.45.1.10.2.14.5 |
| h3cpseportNotification | node | - | .1.3.6.1.4.1.43.45.1.10.2.14.6 |
| h3cPseProfilesTable A table of objects representing a set of power profiles.
Power profiles can be applied to PoE ports, which have the
effect of automatically setting the priority, power limit
and P… | table | - | .1.3.6.1.4.1.43.45.1.10.2.14.7 |
| h3cPOEPowerObjects | node | - | .1.3.6.1.4.1.43.45.1.10.2.14.8 |
| h3cPsePolicyMode The PSE policy only applies to the situation that when a new
board (PSE) is inserted, and the power is overload.
A value of priority(2) means that the power will stop supplying
to… | scalar | Enumeration | .1.3.6.1.4.1.43.45.1.10.2.14.9 |