DTI-MIB Table View

This table describes the DTI protocol related information
contained in Server and Client Frames of a DTI 
client-server pair.

This table is an extension of dtiProtocolTable for the
control of individual DTI Client-Server connections.

The DTI protocol performance metrics of a DTI
Client-Server Connection. In the DTI server an entry
of this table registers the DTI Client frames performance.
In the DTI client the measurements 
correspond to the DTI server frames performance.

The Traceable Path information sent from the DTI server
to the client. The traceability path includes node 
information about DTI root server and DTI server (proxy).
The entries of this table are pointed by dtiProtocolTable
in both DTI Server and Client.
The DTI server may aggregate in a single entry all the 
root-to-server traceable paths that are common across
multiple DTI clients.

Statistics associated to the DTI client state machine.
This table contains counters of the most significant
DTI finite State machine transitions and states as 
reported in the DTI Client Frame.
          
Below is a description of the State Transition and 
counters supported (not all State Transitions need 
object definitions):
          
T1: Warmup to Free-run
  Normally once after the clock warms up. 
  Rather than defining a counter for this 
  state transition, the managed system updates
  the object ifDiscontinuity with the time when
  the clock performs a transition to Free-run 
  State
T2: Free-run to Fast 
  Not defined counter. T2 = T3 + 1
T3: Fast to Free-run (dtiProtocolClientFsmStatsT3Count)
T4: Fast to Normal (dtiProtocolClientFsmStatsT4Count)
  Counts the times the clock enters to the normal
  mode of operation.
T5: Normal to Bridging
  Not defined counter. T5 = T6 + T7
T6: Bridging to Normal (dtiProtocolClientFsmStatsT6Count)
T7: Bridging to Holdover (dtiProtocolClientFsmStatsT7Count)
T8: Holdover to Fast 
  No counter defined. 
  If DTI Client State is Holdover, T8 = T7 - 1 
  other DTI Client State, T8 = T7
          
This table also includes the active time the DTI client is
in Normal state(dtiProtocolClientFsmStatsNormalActiveTime)
and Holdover state 
(dtiProtocolClientFsmStatsHoldoverActiveTime).